dwexpress
Well i just installed the new version and the px1 won't even start. Uninstalled it deleted all the evga folders and did a disk cleanup, then rebooted the computer reinstalled the newest version and nothing. I looked in my installed programs and led sync and px1 are both installed but program wont start even as an administrator. I have 2x 2080ti ftw3 cards. 

DisplacerGoat
Re: red LEDs, two fans showing, etc. On 2080ti Ftw3 : Same issues here. Still chatting with tech support. I'll happily share a fix if it is discovered.

greg.demaria
 

d.burnette
 
I will tell you how I save a profile that works for me.
In PX1, I make my adjustments. Which in my case is Power and Temp target sliders on full. Manual fan curve activated (check box selected) and then a custom fan curve created. I like a little more aggressive fan curve for all three of my fans than the default.
 
Once I have the above, I left click on a profile number (which turns the box purple), and then I click the Save button.
Once saved, if I select another box, the profile number will be a purple reflecting there is a profile saved there.
After that, whenever I want to load up my profile like after closing PX1 for a time being, or restarting the PC - I left click the profile number to select it, and then clock on the Load button. No need to click on either apply or save after loading the profile, only need to click the Load button.
 
Hope this helps,

d.burnette, Thanks so much, that really clarifies the profile save/load process, I really appreciate it! :)

felipy2k
does anyone knows how to get the sensor read in memory modules?

dwexpress
It looks to me like px1 0.3.7 firmware update is what has caused my issues, only shows 2 fans, 3 red lights above power connections, looks like i need the newest firmware/bios updates for my 2080ti ftw3 ultra cards. When i try this link   it gives error device not supported.