Hi,
I received my FTW3 3090 today and everything has been working great so far.
The only strange thing I noticed is that the newest version of Precision X1 only shows the GPU Temp when I click on iCX.
Any idea what I could try to see the MEM and PWR temps?

Sajin
Try this...

#1 Uninstall precision.
#2 Shutdown pc.
#3 Unplug pc from wall.
#4 Hold case power on button for 30 seconds.
#5 Plug pc back into wall.
#6 Turn on system, install precision, reboot pc.

That worked! ...all PWR and MEM temps are now showing up.
Thank you so much! 

Sajin
Glad to hear it worked for you. 👍

I apologize for responding to such an old post; have you seen your solution not work for other people? I've followed the instructions provided to yaxus but no luck on my end.
PX1 still only showing GPU temp in iCX. Card is a 3090 XC3 ULTRA so it should be capable. Fresh Windows install and everything. I have a EVGA 1070ti installed also if that matters. The only oddity I see is that when launching PX1 there is an error message that flashes quickly and disappears. "Unable to load DLL 'nvml.dll': The specified module could not be found. (Exception from HRESULT: 0x8007007E)
This install message has always happened on every installation of PX1. I'm going to try reloading the drivers and then reattempt.
Thanks
EDIT: I have removed/uninstalled the following:
GPUz
Afterburner
PX1
Restarted Rig
Downloaded Nvidia drivers fresh from website. Did a 'Clean' install
Restarted
Installed PX1
Restarted
Started up PX1, no more error message (see above) but the only temp reading I'm seeing is the GPU. Not sure where to go from here aside from submitting the 'bug' (?) to EVGA.

walidnsu
As per the evga gpu specification, only FTW GPU seriese (with iCX3) have 9 heat scensor which is not your model. That is why you are seeing only the GPU temp. 

Ah dang, didn't know it was only that series of cards.
Thanks for that info.

jrossetti
I got my 3090 from dell, how do i see if it's an icx card? 

I think it is as I have memory junction and thats low, gpu which is low, but then i also have hotspot, which is 107c so there's at least 3 different sensors in there.
 

A DELL card would not have EVGA technology. ICX is from EVGA.

Hello All, 
 
I have a 3090 Kingpin and I seem to have lost all of my ICX sensors and also the ability to change my LEDs and also the LCD screen on the card. 
 
I have gone through the procedure outlines above. Just noticed the issue after I installed the latest nVidia Drivers (511.65).  
 
I have uninstalled PX1, shutdown and unplugged the PC etc as the instructions above state.  Below is a screen shot of PX1.
Not sure what to do here. I am not seeing the sensors is HWinfo or GPU-Z either. 
 
Any ideas or suggestions? 
Thank you, 
J

I did a clean install of the latest driver and that seems to have fixed the issue. That was really odd, and not sure what would cause that. 
Thank you for your help, looks like I am good to go for now. 
-J