Ok So a little background. I have been Mining (ETH) with my 2 EVGA Graphics cards when not using my desktop PC, and one of the most important features that I have been using through Precision X1 is the feature lets you set the EVGA Graphics Cards LEDs to display certain colors at certain temperature thresholds so as to have a visual warning of overheating. Which before the most recent firmware update would stick  (i.e. once set would stay) to both my RTX 2080 TI Black, and my RTX 3090 TI Black even once I Closed the Presicion X1 Program even after a PC restart, allowing me to glance at my clear desktop case from time to time to make sure neither card gets above a certain temperature (which again I could visually see based on the Cards LED Colors even with the monitor off). This was very important that it would stick once I set the feature because while I run the mining program I turn off all other apps and programs while mining which increases the hash rates. And now After I updated the RTX 3090 TI's Firmware using X1 yesterday, the Color temperature LEDs do not update (meaning refresh) anymore the moment I close precision x1. Strangely enough, even after restarting the cards LED settings do stay set to display temperature LEDs however they simply never refresh until I open precision X1. Please fix this, or allow us to downgrade our firmware and download an older version of Precision X1 thanks. Please See Screenshot of versions below
 
 
 

Sajin
Time to contact evga tech support… https://www.evga.com/about/contactus/

For what? To have them tell the OP that he voided his warranty by mining on them?
 
https://www.evga.com/warranty/graphics-cards/

• Any damages to the components, hardware and/or assembly of the Products including but not limited to damages caused as a result of neglect, abuse, accidents, misuse, or unusual physical, electrical or electromechanical stress (including due to uninterrupted use of the Products, or use of the Products for blockchain processing, cryptocurrency mining, or similar purposes).

I had the same issue with leds. The easiest fix is to go led tab, change the numbers of leds under the powerlink ( fourth picture on the right) and also change it to static off under that. Hit apply. Now it will work fine for all of the other leds. Please let me know if it works for you as you are not the only one. You can change it to anything else after that and the led will work fine to whatever setup you want.

Fixed