rtfrisk
New Member
- Total Posts : 1
- Reward points : 0
- Joined: 2021/11/25 01:00:24
- Status: offline
- Ribbons : 0
Hello - I am installing the CLC 360, and have the backplate and standoffs in place and tightened by hand, and I notice there is quite a bit of play (loose wobble) and was just making sure that this is normal behavior before continuing with the rest of the install. Is the backplate meant to cinch when the pump is installed and screwed down? Thanks! *Nevermind, it turns out this IS normal behavior and that once I tightened down the block the whole setup tightened up.
post edited by rtfrisk - 2022/01/16 19:40:03
|