So I was wondering if anyone has used a Corsair Obsidian 600T case with the ECP.  How were you able to mount it in one of the 5.25" bays?  The cases doesn't use screws to secure the drives in place, it uses this locking clip you push down on.  I can't find a place to screw the ECP in.

Hello guys i just have a little problem on my EVGA FTW z68 motherboard i received the screws but no ribbon with the ECP V4.... where can i buy one? Or just email evga to received one please? Cause i took the FTW Z68 with gauge and ecp just for that to overclock so... i'm disappointed...

Thanks Jacob, for these instructions. They are what is needed.
 
Be advised long cards squash the large connector(below the rt angle SATA's). So it results in limiting the number of slots available for a two way SLI.
 
I even dressed the wires to keep them as flat as possible but the GTX480 won't fully seat without pinching the wire between the connector top and the the bottom of the 480. What results is a non-fully seated card edge connector and removal is tricky. I could grind down an 1/8" but I just can bring myself to do that. The only other long card option is to put the second 480 in the #4 slot cramming the 2-way SLI card into the closest proximity reducing the air flow between the cards.
For an SLI I'll just have to move my 560 Ti's in this case because they are short and do not collide with the header connectors.

Correct, red wires facing up on the 5.25" panel.

cktype

i can't believe the 5.25 panel went up to 21.99 on evga's website...argh. anyone willing to sell theirs?

you can have mine for $30+ shipping

At first I thought the unit was giving me a code 2A? but I think the bottom row/bottom right light is dead? Cause if it was it would be showing 28 just like the mobo saying 28. Hmm is mine bad? lols

How can hook up of them i dont understands some parts of these pic and overview of them please tell me in detailed and desperately.

Jacob - You sir, are a life saver!   These instructions were just what I needed to finish up my new build.
The photos and your narrative makes it even better. 
 
One request.   The manual for this board (P67K2) is minimal at best.  Would you ask the powers that be at EVGA if it would be possible to go back to the way that EVGA manuals used to be written?  I found the 790i one particularly helpful due to its amount of content.  It really helped a dummy like me make the build more fun.  This one was kind of a chore in comparison.
 
Thanks for all of the good work that you do to help us on the forums.

 
Ok, I hooked it up. This control panel while in Windows only shows the post codes. Why isn't it showing the CPU temp? Is there a setting in the Bios that needs to be changed?

Lvcoyote

Yes, there is a BIOS setting to either have it display the current post code or the temp. Changing that will also change the LED display on the motherboard to do the same.

So I can't have the Mobo display the codes, and the control panel display the CPU temp at the same time?

Lvcoyote

No, the control panel just duplicates what the onboard LED displays.

Oh I see. Appreciate the info.
 

Lvcoyote

Yes, there is a BIOS setting to either have it display the current post code or the temp. Changing that will also change the LED display on the motherboard to do the same.

 Forum member "Wrinvert" will be going over all my Bios settings with me in a few minutes. I think this issue, and a few others will be resolved as soon as the Bios settings are corrected.