EVGA
Prev Thread
Next Thread

Board won't POST after BIOS update

Author
Post
Essentials Only Full Version
lfgengineer
New Member
  • Total Posts : 1
  • Reward points : 0
  • Joined: 12/4/2018
  • Status: offline
  • Ribbons : 0
Tuesday, December 04, 2018 12:36 AM (permalink)
I have a z270 Classified K motherboard and I did a BIOS update to 1.08 using the EVGA Windows installer.  According to the progress screen, the process completed properly, but when the system rebooted, it won't even POST.  Suggestions?
#1

2 Replies Related Threads
    Sajin
    EVGA Forum Moderator
    • Total Posts : 49227
    • Reward points : 0
    • Joined: 6/8/2010
    • Location: Texas, USA.
    • Status: offline
    • Ribbons : 199
    Re: Board won't POST after BIOS update Tuesday, December 04, 2018 6:53 PM (permalink)
    Use the bios switch on the motherboard to load up off another bios.


    See my current build here: https://forums.evga.com/My-bench-rig-unlimited-power-m3596024.aspx
    RTX 2080 Ti 4-way SLI?!?!: https://forums.evga.com/RTX-2080-Ti-4way-SLi-set-by-yours-truly-m2954756.aspx
    #2
    Tech_RayH
    SSC Member
    • Total Posts : 834
    • Reward points : 0
    • Joined: 5/13/2016
    • Status: offline
    • Ribbons : 7
    Re: Board won't POST after BIOS update Tuesday, December 04, 2018 7:58 PM (permalink)
    After you have booted up on the second BIOS (as Sajin suggested), while running in Windows, move the switch back the original position. Then you can attempt to flash the original BIOS position a second time (from Windows). This process can be repeated, but it does not work after two attempts, there is likely some other issue and we would recommend reaching out to our support staff, 888-881-3842.
     

    ...an untrammeled flow of words in an open forum.
    - Adlai E. Stevenson
     
    #3
    Home » All Forums » [EVGA Motherboards] » All Other EVGA Motherboards » Board won't POST after BIOS update
    Jump to: