EVGA

Hot!BIOS Updates for X299 Dark (1.29) / FTW K (1.29) / Micro ATX 2 (1.22) / Micro ATX (1.30)

Page: < 12 Showing page 2 of 2
Author
ZoranC
FTW Member
  • Total Posts : 1024
  • Reward points : 0
  • Joined: 2011/05/24 17:22:15
  • Status: offline
  • Ribbons : 12
Re: BIOS Updates for X299 Dark (1.29) / FTW K (1.29) / Micro ATX 2 (1.22) / Micro ATX (1.3 2022/03/24 17:08:28 (permalink)
Today I updated BIOS on my X299 Dark from 1.28 to 1.29. If I am correct BIOS’ hardware monitor reports NXP MCU temperatures are approximately 2C higher after the update than they were before. Has anybody else observed same?
#31
Papa_P
New Member
  • Total Posts : 4
  • Reward points : 0
  • Joined: 2022/06/15 11:52:42
  • Status: offline
  • Ribbons : 0
Re: BIOS Updates for X299 Dark (1.29) / FTW K (1.29) / Micro ATX 2 (1.22) / Micro ATX (1.3 2022/06/20 13:06:08 (permalink)
I installed this update, and updated my GTX 1080 with this software:

I was attempting to install windows 11 and this driver allowed me to disable CSM, I had no video output in BIOS until I installed that driver. I installed it and I was able to disable CSM and still have video output. I booted into windows to make sure everything was ok and it seemed so. So I went back into BIOS to enable Secure Boot and my problems returned, only this time I couldnt bypass BIOS Setup into Windows to flash the BIOS. I am stuck with no video and a POST code of D6, No Console Output Devices are found. Tried another GPU and the same issue is present, D6. So my motherboard just doesn't detect GPUs anymore? Its fans run and it lights up. Any suggestions? Thanks!
#32
nekrosoft13
New Member
  • Total Posts : 44
  • Reward points : 0
  • Joined: 2006/11/04 10:12:04
  • Status: offline
  • Ribbons : 0
Re: BIOS Updates for X299 Dark (1.29) / FTW K (1.29) / Micro ATX 2 (1.22) / Micro ATX (1.3 2022/07/21 16:05:15 (permalink)
looks like another update is needed..
 

post edited by nekrosoft13 - 2022/07/21 16:08:29
#33
PINKTULIP
FTW Member
  • Total Posts : 1157
  • Reward points : 0
  • Joined: 2007/06/03 16:01:19
  • Location: EARTH
  • Status: offline
  • Ribbons : 7
Re: BIOS Updates for X299 Dark (1.29) / FTW K (1.29) / Micro ATX 2 (1.22) / Micro ATX (1.3 2022/07/28 09:53:29 (permalink)
EVGATech_LeeM
New Updates for X299 Motherboards today.  This updates the ME for an Intel security vulnerability:

BIOS 1.29 (E299 Dark) / 1.29 (E297 FTW K) / 1.22 (E296 Micro ATX 2) /1.30 (E295 Micro) Updates 

  • Update ME firmware to 11.12.90.1962v10 for Intel security vulnerability.
 



Windows Installation
  • Download the correct .zip file below for your motherboard:        
         151-SX-E299-KR - EVGA X299 Dark - v1.29
        142-SX-E297-KR - EVGA X299 FTW K - v1.29
        121-SX-E296-KR - EVGA X299 Micro ATX 2 - v1.22
        131-SX-E295-KR - EVGA X299 Micro ATX - v1.30
  • First go into your BIOS and load defaults, save and exit
  • Close all open programs.
  • Go into the folder where you unzipped this package and double-click update.bat
  • Press Y to start the flash process
  • DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
  • After the flashing is finished, the system will automatically shut down. Then power on again and go into BIOS to setup.
  • NOTE: If flash box immediately closes after flash attempt, the flash may need to be ran from a CMD prompt with administrator privileges or DOS version.
  
BIOS Installation
  • Extract the contents of .zip file to USB flash drive (must be formatted as FAT32)
  • Reboot the machine and go into the system BIOS
  • From the BIOS, navigate to the Save & Exit tab and open "Select BIOS File."
  • Select the .bin file you wish to flash.
 
Please let me know if anyone runs into problems with this update.  Thanks!


I am requesting new BIOS 1.30 because I believe when Above 4G Decoding Enable in the Bios 1.28 and 1.29 it cause USB Device not detected time to time!!!!!!!!!

MOBO :EVGA X299 DARK 151-SX-E299-KR  BIOS :1.29 CPU : Intel Core i9-10900X Skylake-X 10-Core 3.7 GHz  LCR :Corsair Hydro Series H80i V2 GPU :SAPPHIRE NITRO+ RX 6900 XT SE MEMORY: CORSAIR Dominator Platinum SE Torque 32GB (4 x 8GB) CMD32GX4M4C3200C14T SSD 01: SAMSUNG 970 PRO M.2 1TB NVMe SSD 02: SAMSUNG 860 PRO 256GBX2 Raid 0 PSU : Seosonic Prime Titanium SSR-1000TR 1000 Watts CASE :Thermaltake (Armor+) VH6000SWA SC :Creative Sound Blaster AE-9 5.1 Channels Monitor  Acer XR382CQK  IPS 3840x1600 @ 75HZ BD [/
#34
the_Scarlet_one
EVGA Forum Moderator
  • Total Posts : 23699
  • Reward points : 0
  • Joined: 2013/11/13 02:48:57
  • Location: East Coast
  • Status: online
  • Ribbons : 77
Re: BIOS Updates for X299 Dark (1.29) / FTW K (1.29) / Micro ATX 2 (1.22) / Micro ATX (1.3 2022/07/28 15:07:06 (permalink)
PINKTULIP
I am requesting new BIOS 1.30 because I believe when Above 4G Decoding Enable in the Bios 1.28 and 1.29 it cause USB Device not detected time to time!!!!!!!!!


Lee already replied in your thread.

<- Main PC Specs
 
<- mATX build
#35
Page: < 12 Showing page 2 of 2
Jump to:
  • Back to Mobile