willm1224
LegendOfSomething
So i have still found that the xc3 bios are still the best for over clocking, but has anyone else tested using aurous OC engine over afterburner to get more accurate fan control with xc3 bios?
I found an annoying but accurate way to control fans with AB, if you set the fan percent on the main screen, it’ll jump to what it’s actually using and show you. So I wanted 80 I had to run 86% if I want 70% plug in 79% to AB, 55% actual is 69% in AB 50% is 65. It’ll run it correctly it’s just off. Since 100% does reach 100% rpm speed, any number you want is attainable.
thanks for the reply! that does make sense, i did notice the fan number dropping after setting. I would prefer to run my fans at 100% all the time but i could settle at 95%. The only other issue i noticed though, is when playing gta V, I had my overlay on to monitor my fan rpm, and it would go from 3000 rpm to 2500, to 2700, 2800, than spike to 6000, than back to 3000 and repeating. I verified with my eye balls that all fans are actually running, but couldnt tell with the weird rpm charts if my fan speeds are actually going up and down than spiking. But it could be a bit concerning when it spikes the rpm like that on the overlay if it is actually spiking power the fans in real time as this may cause excessive wear if this is the case but i couldnt verify. if the aurous engine seems to make the fans stable, I could just switch to that and port over my same OC from AB. But i guess if no one else ends up having input on this, I may just have to try to test my self XD