I built this rig a few months ago, basically a temporary build until I can put together a Z590 rig. I was only going to post this one on ModsRigs.com, but since there is apparently some issue going on there for the last 2 weeks and nobody can add new builds, I'll just post it here in the meantime. Here's the components list:
Intel i7-10700k CPU (water cooled)
EVGA RTX 3090 FTW3 Ultra (water cooled)
Corsair Dominator Platinum 4000MHz 2x16GB
EVGA Z490 Dark KingPin edition motherboard
EVGA SuperNOVA 1000 T2 PSU
Corsair Crystal 680X RGB case
Samsung 970 Pro NVMe m.2
2 x Corsair 280mm radiators
4 x be quiet! SilentWings3 high speed 140mm PWM radiator fans
EKWB Quantum Vector GPU block and backplate
Optimus Signature V2 CPU block
Corsair XD5 pump/reservoir combo
All fittings are Corsair Hydro X series.
ASUS Strix riser cable
Grizzly Kryonaut tim
Overclocked the i7-10700k CPU to 5.2GHz stable and the RTX 3090 FTW3 Ultra to 2.05GHz stable and ran 3D Mark Port Royal and scored 14,317 [
link] which is pretty nice. It appeared there was room for higher clocks on the 3090 but this is really only a temporary build so I was good with that result. RAM was just running at XMP settings.
Loop order is res/pump -> GPU block -> CPU block -> bottom radiator -> top radiator -> res/pump.
Running AIDA64 System Stability Test at full load on both CPU
and GPU at the same time (so pushing the cooling pretty hard), with ambient at 77°F, after 10 minutes the CPU @5GHz had leveled off around 70°C (all cores) and the GPU @2040MHz leveled off just touching 60°C. Not bad.
It was a bit of a mission getting all that gear in a 680X ATX case. Some photos:
The components..
Motherboard, radiators, CPU block, pump/res and some tubing installed, including a drainage line with ball valve..
Vertical mounted 3090 added..
Showing just how packed it was fitting all this into the ATX case..
15 minute pressure leak test - successful..
IT'S ALIVE!..
post edited by Nereus - 2021/06/06 18:02:43