I got my 680 FTW today and it works well.  EVGA delivers again!  Although I probably dont need to keep my 285 going as well I am running my 32" TV as an accessory monitor off of it.
 
The problem is if I switch to view the 285 and then back to the 680, 680 shows a low clock and the base / boost carrots are gone.  Doesnt actually down clock the card just shows lower so pretty much just a bug in the software i think.   
 
OC scanner / NV-Z show the correct unchanged speeds just precision itself shows incorrectly.  
 
I did a total removal off all evga software and re-install when I found this issue, it didn't help.  
 
 
Suggestions-
I would also like to be able to set different fan profiles on the different cards, is this currently possible and I am just missing it?
 
I would also like to be able to stress 2nd card at the same time or separately I know I have seen a post about that before just throwing it in there.   
 
Attached are before and after of the issue.
 

 

 
 
Edit: 3.0.3 which came out today seems to have fixed the incorrect display of clocks.