EVGA
Prev Thread
Next Thread

Precision X1 showing one fan at 0 rpm

Author
Post
Essentials Only Full Version
teamynil
New Member
  • Total Posts : 5
  • Reward points : 0
  • Joined: 5/26/2021
  • Status: offline
  • Ribbons : 0
Wednesday, May 26, 2021 7:59 PM (permalink)
Hello,

 
I use the EVGA precision X1 software to manage my fan curve.
A few days ago I noticed that one of my fan (FAN 1) always displays 0 rpm even if it should spin according to EVGA software (screenshot attached)
 
I may have notified this since the last precision update which also updated the graphic card firmware.
 
Do you think it could a software/firmware issue ? Or do you think it could be a hardware issue from the fan ? I have checked the fan on the graphic card and it is not spinning.
 
Thank you for your answers

Attached Image(s)

#1

4 Replies Related Threads
    DNVSck
    Superclocked Member
    • Total Posts : 101
    • Reward points : 0
    • Joined: 12/17/2018
    • Status: offline
    • Ribbons : 0
    Re: Precision X1 showing one fan at 0 rpm Wednesday, May 26, 2021 8:29 PM (permalink)
    Do spot any difference when you spin the fan by hand in comparison to the other two? Is it harder?
    If yes maybe then it is a defective fan.
    You can also load the GPU and monitor the temps and fans and check if the third one starts spinning.
    #2
    teamynil
    New Member
    • Total Posts : 5
    • Reward points : 0
    • Joined: 5/26/2021
    • Status: offline
    • Ribbons : 0
    Re: Precision X1 showing one fan at 0 rpm Thursday, May 27, 2021 6:32 AM (permalink)
    Hello,
     
    No difference between the fans when I manually spin them.
     
    I have check the three fan connectors, all well seated.
     
    I played a 4k game yesterday, the graphic card temperature was 85 degrees and only two fans were spinning :(
    #3
    DNVSck
    Superclocked Member
    • Total Posts : 101
    • Reward points : 0
    • Joined: 12/17/2018
    • Status: offline
    • Ribbons : 0
    Re: Precision X1 showing one fan at 0 rpm Thursday, May 27, 2021 7:05 AM (permalink)
    Probably you should contact EVGA support. Maybe there is a feature/setting we are missing.
    #4
    teamynil
    New Member
    • Total Posts : 5
    • Reward points : 0
    • Joined: 5/26/2021
    • Status: offline
    • Ribbons : 0
    Re: Precision X1 showing one fan at 0 rpm Thursday, May 27, 2021 7:13 AM (permalink)
    I contacted them, wainting for an answer.
     
    I hoped that someone knew this issue since I saw tyhe same kind of issues on other threads.
     
    Thank you anyway for your answers
    #5
    Home » All Forums » [Graphics Cards] » EVGA GeForce RTX 30 Series » Precision X1 showing one fan at 0 rpm
    Jump to: