EVGA
Prev Thread
Next Thread

EVGA 3080 FTW3 stripped backplate screw

Author
Post
Essentials Only Full Version
Tackers777
New Member
  • Total Posts : 2
  • Reward points : 0
  • Joined: 10/22/2016
  • Status: offline
  • Ribbons : 0
Saturday, January 08, 2022 3:42 AM (permalink)
Hey all, I was attempting to install an ekwb vector block on my 3080. I got to the final screw and it just went haywire. It is completely stripped no thread what so ever.

What should I do??? I'm panicking so bad right now.
#1

2 Replies Related Threads
    rjbarker
    CLASSIFIED Member
    • Total Posts : 2361
    • Reward points : 0
    • Joined: 3/20/2008
    • Location: Vancouver Isle - Westcoast Canada
    • Status: offline
    • Ribbons : 21
    Re: EVGA 3080 FTW3 stripped backplate screw Saturday, January 08, 2022 5:33 AM (permalink)
    You have to get McGiver with it :)
    There are screw extractors....or try the rubber band trick (google it)...

    I9 12900K EK Velocity2 / ROG Z690 Apex/ 32G Dominator DDR5 6000/ Evga RTX 3080Ti FTW3  EK Vector / 980 Pro 512G / 980 Pro 1TB/ Samsung 860 Pro 500G/ WD 4TB Red / AX 1600i /  Corsair 900D & XSPC 480 * 360 * 240 Rads   XSPC Photon 170 Rez-Vario Pump Combo - Alienware 3440*1440p 120Hz/ W11
     
    #2
    Flint 1760
    Omnipotent Enthusiast
    • Total Posts : 8149
    • Reward points : 0
    • Joined: 4/26/2009
    • Status: offline
    • Ribbons : 45
    Re: EVGA 3080 FTW3 stripped backplate screw Saturday, January 08, 2022 12:24 AM (permalink)
    Did you strip the screw or did you strip the threads in the block?
     
    If it is the latter, then you have to do a DIY heli-coil on the block, i.e., build up the hole and then re-cut the thread.  You could use the next size up screw, however you may not be able to do this and it will depend on the location and placement of the screw hole.
    post edited by Flint 1760 - Saturday, January 08, 2022 12:40 AM


    #3
    Home » All Forums » [Graphics Cards] » EVGA GeForce RTX 30 Series » EVGA 3080 FTW3 stripped backplate screw
    Jump to: