EVGA

Kingpin Temp Question

Author
Carmen813
Superclocked Member
  • Total Posts : 202
  • Reward points : 0
  • Joined: 2012/03/26 14:32:10
  • Status: offline
  • Ribbons : 0
2021/02/11 20:27:56 (permalink)
Hey folks,
I am running my kingpin as the intake on a push/pull in my Lian Li Dynamic OXL. Ambient temperatures are around 78F. Running a port royal stress test at 4k GPU temperatures hit around 62c with +125/500 and 100mv. Feels like that is toastier than I remember it being when I first got it, any thoughts on if that sounds about right? I have it mounted so tubes are down (top of radiator is much higher then pump)

#1

3 Replies Related Threads

    _Gir_
    iCX Member
    • Total Posts : 333
    • Reward points : 0
    • Joined: 2016/02/02 20:12:10
    • Status: offline
    • Ribbons : 2
    Re: Kingpin Temp Question 2021/02/11 20:37:02 (permalink)
    Fans on max? Try taking side panel off. Could try redoing the thermal paste on GPU, mine was not great. Also 62C is not unreasonable for 78F ambient. I’m 75 ambient and temps will get to 55 on an open bench.
    #2
    Dabadger84
    CLASSIFIED Member
    • Total Posts : 3426
    • Reward points : 0
    • Joined: 2018/05/11 23:49:52
    • Location: de_Overpass, USA
    • Status: offline
    • Ribbons : 10
    Re: Kingpin Temp Question 2021/02/11 20:42:41 (permalink)
    Given that ambient, that temp is warm, but not "high high".
     
    What is your current fan setup?  Post a picture of the system if you can.  I would try to get as much intake going on as you can and maybe reverse the flow on the GPU radiator so it's exhaust instead of intake - see what works best for temperatures overall.  What's the rest of your system specs?

    ModRigs: https://www.modsrigs.com/detail.aspx?BuildID=42891  
    Specs:
    5950x @ 4.7GHz 1.3V - Asus Crosshair VIII Hero - eVGA 1200W P2 - 4x8GB G.Skill Trident Z Royal Silver @ 3800 CL14
    Gigabyte RTX 4090 Gaming OC w/ Core: 2850MHz @ 1000mV, Mem: +1500MHz - Samsung Odyssey G9 49" Super-Ultrawide 240Hz Monitor
     
    #3
    Carmen813
    Superclocked Member
    • Total Posts : 202
    • Reward points : 0
    • Joined: 2012/03/26 14:32:10
    • Status: offline
    • Ribbons : 0
    Re: Kingpin Temp Question 2021/02/11 20:57:14 (permalink)
    Figured it out, issue with fan profile. I have fans on a pwm controller and thay is connected to a fan header on kingpin pump. Had profile speed to low so they weren't moving much air.

    Using push pull with 3x ml120 and 3x ekwb vardar
    post edited by Carmen813 - 2021/02/11 21:02:58

    #4
    Jump to:
  • Back to Mobile