EVGA
Prev Thread
Next Thread

No video signal from onboard

Author
Post
Essentials Only Full Version
rholdcroft99
New Member
  • Total Posts : 27
  • Reward points : 0
  • Joined: 4/21/2016
  • Status: offline
  • Ribbons : 0
Friday, November 18, 2016 0:30 PM (permalink)
Hey all, I just removed my 980ti ftw to send in for step up, now I'm not getting any video signal from sabertooth z97 onboard graphics.  How can I make onboard graphics work?
#1

3 Replies Related Threads
    bcavnaugh
    The Crunchinator
    • Total Posts : 38516
    • Reward points : 0
    • Joined: 9/19/2012
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: No video signal from onboard Friday, November 18, 2016 1:35 AM (permalink)
    Enable it in the Bios, you will have to Reset your Bios to do this. (Clear CMOS switch) on the MB or Real Panel.
    Before you removed your card for step-up did you Remove the Drivers and run DDU to clean out your computer?
    This needs to be done before you install your new step-up card.
    post edited by bcavnaugh - Friday, November 18, 2016 1:41 AM

    Associate Code: 9E88QK5L7811G3H


     
    #2
    the_Scarlet_one
    formerly Scarlet-tech
    • Total Posts : 24080
    • Reward points : 0
    • Joined: 11/13/2013
    • Location: East Coast
    • Status: offline
    • Ribbons : 79
    Re: No video signal from onboard Friday, November 18, 2016 2:36 AM (permalink)
    Moving to general hardware. This is an ASUS board in question.


    TSgt Matthew Schwartz  SrA Bryan Bell A1C Matthew Seidler SSgt Joseph Fankhauser
    #3
    MDeckerM
    FTW Member
    • Total Posts : 1683
    • Reward points : 0
    • Joined: 9/22/2015
    • Location: RwlRwlRwlRwl
    • Status: offline
    • Ribbons : 8
    Re: No video signal from onboard Friday, November 18, 2016 2:37 AM (permalink)
    You can always clear your CMOS to reset your bios settings back to factory defaults.
    #4
    Home » All Forums » [Computer Hardware & Software] » Hardware » No video signal from onboard
    Jump to: