https://imgur.com/B3hHJw6 this is the picture

Yeah thats aboslutely right bro

sam_dude97
Yeah thats aboslutely right bro its exactly where the acx 3.0 logo is located. Any idea what should i do?

Hello,
 
I apologize that this has occurred as it is not a common issue.
 
If you want to avoid sending the product in for warranty and feel comfortable fixing the issue yourself, the decal is held to the shroud using a padded two sided sticky tape. If you remove the decal carefully you can replace the tape and re-apply the decal.
 
Otherwise, the decal is purely cosmetic and its delamination will not affect cooling performance.
 
Thank you
 
 

Yeah i really want to avoid sending in the product cause iam in pakistan. Thanks fpr your quick reply. Can you give me more precise steps to rectify this issue

sam_dude97
Yeah i really want to avoid sending in the product cause iam in pakistan. Thanks fpr your quick reply. Can you give me more precise steps to rectify this issue

sam_dude97
Yeah they should have used something sturdy than a double stick tape

use a exacto type knife to gently peel it off, maybe some heat from a hair dryer ( if you use a heat gun use the low setting, just want to warm it up and not melt anything ) as it will soften the adhesive. then use some 3m VHB duoble stick, the thin version and use the exacto to trim it to fit. make sure the contact surfaces are clean also. 
 
as for something more sturdy this is the first i have ever seen someone having one come loose like that but it does happen, the factories crank out thousands of these so you will have a few bad ones come up.  

sam_dude97
Thanks a lot bro i will try to but i think it not that much of a big issue i can live with that

it would drive me up a wall with it bowed like that