I also saw these yesterday and gave a quick google and got linked here, I would be interrested to see some pictures when you get it and would love to see the build. I want to see what these look like with an opaque liquid in.
 
I am hoping they will make one for the Evolv X ASAP.
 
Not too sure on their marketing photos of these, I don't think they do them justice, to much RGB everywhere.
 

Its here!!!



 
 

This looks awesome thanks for posting up the pictures. Would like to see the LED Strip installation. What pump are you using, is it a specific barrow pump? Looks like a DDC? Did you have to buy a separate adapter?
 
If possible some pictures of the pump fitment would be great.
 
I see the IV on the reservoir section but are you going to add another drain position off the pump at the lowest point?
 
This is going to look really nice in the case. Can't wait for some more pics.
 
 
 
 

brad257
This looks awesome thanks for posting up the pictures. Would like to see the LED Strip installation. What pump are you using, is it a specific barrow pump? Looks like a DDC? Did you have to buy a separate adapter?
 
If possible some pictures of the pump fitment would be great.
 
I see the IV on the reservoir section but are you going to add another drain position off the pump at the lowest point?
 
This is going to look really nice in the case. Can't wait for some more pics.

Thanks!  Now to answer your questions.  I took out the Barrow LRC RGB v2 RGB strip snice its 3pin and bought an Alphacool 30cm 4pin RGB strip which will fit nicely, might have to snip an LED off.  With it being 4pin I can connect it to the Farbwerk along with the XPX. The channel for the LED strips in this model is 11mm tall, 2.9mm wide and around 290mm long around 11.5in, I used a set of digital calipers to get these measurements.  So I bought the Barrow SPB17-T-V2 DDC pump kit.  All I need was the top it comes with some very strange DDC pump, but I am just using the special top from the kit.  I will be using my DDC 3.2 PWM EK pump and trimming the DDC heatsink slightly in the cable cutout to accommodate a 4pin PWM pump.  I had to order some M4x55mm screws to sandwich this all together on the plate.  I actually will not be using the Ball valve and installed it as an example.  I will be using my QDC's from the previous build.  I will get you some photos of how the DDC should be installed.    

Very strange, has some plastic molded into the PCB

This is how its suppose to be setup, with the special DDC top.