mrblond
Been waiting for one of these to come available but its pushed my case choices into limbo again. Id really like to mount it to the rear but not many cases will take a 240 rad there.
 I have a o-11 evo in my cart but now i am rethinking things.. I also was loking at the 1000D but while it looks like i could mount it there, the bloody thing is massive and i dont want to go broke filling it with rgb fans.
 
any other recommendations? I have a feeling i will need to mount it either on the side of the o-11 which i guess could work, or grab that house they call a computer case.

I'm not sure whether I am going to mount a hybrid cooler on my 3080Ti FTW Ultra. Even running MSFS2020, which does a major job heating up the GPU, it tops out @ 75C @ 50% fan speed. It's as quiet as the hybrid I had on my 1080Ti. 75C temps are fine. Same boat as you, what would I replace my modified Corsair 780T (dual 200mm intake fans) with?

Cancel077

mrblond
Been waiting for one of these to come available but its pushed my case choices into limbo again. Id really like to mount it to the rear but not many cases will take a 240 rad there.
 I have a o-11 evo in my cart but now i am rethinking things.. I also was loking at the 1000D but while it looks like i could mount it there, the bloody thing is massive and i dont want to go broke filling it with rgb fans.
 
any other recommendations? I have a feeling i will need to mount it either on the side of the o-11 which i guess could work, or grab that house they call a computer case.

I would personally recommend the O11 XL. It is larger than the evo, I think the evo is just a tad bit larger than the original dynamic but still similar in size (don't quote me on that). However, the XL is the largest of the cases. It fits my hybrid pretty well. I have both of my hybrid and cpu set as an exhaust, and I installed a custom front panel for intake. My bottom fans are intake as well. I would personally buy the XL over the evo for the size alone, but to each its own preference!
 
Below is how my set up currently looks. My apologies for just posting the links as I do not know how to post a picture on here!
https://imgur.com/a/ZeVCpow
https://imgur.com/a/NgE1OvF
 

i was looking at the XL as well but I think it still will only take 1 120mm fan in the back so a 240 rad there wont work

Cancel077

mrblond
 
i was looking at the XL as well but I think it still will only take 1 120mm fan in the back so a 240 rad there wont work

What do you mean by 1 120mm fan in the back? Most cases if not all only take 1 120mm fan at the rear of the case for exhaust.

looking for one that will take 2 of them, sofar the one one I have found is the 1000D

5000D, CPU AIO on the side, GPU AIO on top Rear. 

5000D with 280AIO in the top, GPU radiator in the side. Any particular reason for wanting the radiator in the back?

mrblond
 
i was looking at the XL as well but I think it still will only take 1 120mm fan in the back so a 240 rad there wont work

I love the Lian-Li O11 XL, but you are correct...just one 120mm fan.  A 240 rad will NOT work there.  I've seen a friend do a 360 rad on the top (push - pull exhaust) and a 360 rad on the front (push - pull intake) with a bottom intake (3 x 120). Seemed to work well, but it is not exactly what you are seeking to do.
 
For what it's worth, I prefer to have my case be slightly "positive pressure" to help prevent air (and dust) from sneaking in through areas other than where the dust cover/fans are...I prefer to know where I have to spend the balance of my time cleaning (while having to clean everywhere...who are we kidding).
 
 

I almost pulled the trigger on the o-11 then saw the Z690 Dark may be a tad large and stick over the edge and that is where the power connectors are, not sure if that would be an issue.. more research is needed

I bought the 1000D for this very reason.  Works quite well with a lot of fans installed.

I would get the 7000D at this point and mount the hybrid rad on the side, instead.

Lancool II performance mesh, with the two bottom intake fans and the cooler top exhaust.

mrblond

enewt

fugly16
I'm using a 5000D, 360 AIO at the top and the hybrid 240 AIO on the side.  Both are exhausting.  
 
If I could do it over again though I think I would rather have the Lian Li 011 Dynamic.  

I think it is hard to go wrong with a O11 or O11 XL.  

i am really leaning to the 011 evo.. always wanted a lian li.. and tbh, i dont want to have to buy a bunch of cable extenders to use in the 1000d either.
 
think i can mount the 360 on the top then the hybrid on the side with a 3rd fan.

If you can, tubes from the rad pointing towards the ground (not at the top). Not sure if it will need to be the bottom two 120s or could be the top two, but bottom two will look better.

mrblond
i am really leaning to the 011 evo.. always wanted a lian li.. and tbh, i dont want to have to buy a bunch of cable extenders to use in the 1000d either.
 
think i can mount the 360 on the top then the hybrid on the side with a 3rd fan.

Not sure if you are planning on doing a push/pull on the hybrid. But I really did find it helps with reducing temperatures. Also I'm not sure if you are planning on installing front fans for the evo. However, with all of that, keep in mind that if you don't install front panel fans for intake, then I'm assuming you'll use the hybrid rad on the side as intake. I would recommend against that only because the GPU will pump hot air into your system. I suggest you mount the gpu on top as exhaust and cpu rad on the side as intake because the air coming out of the cpu rad will be cooler than the gpu.

If you decide to have them both as exhausts, then you'll want the front as intake. Just be aware that the push/pull combo might take space from the front fans.

Lastly, I'm not sure if the inside space of the case is smaller in the evo than the XL, but if the space inside is the same as the original dynamic, then your aio tubes will have a tight fit and much more bending with you trying to close the side window than with the XL.

Just a few thoughts before you make a decision.

redteamgo

nomoss
I bought the 1000D for this very reason.  Works quite well with a lot of fans installed.

I would get the 7000D at this point and mount the hybrid rad on the side, instead.

very nice rig. The 1000d is such a beast. Hurricane force airflow 😁

Very nice indeed.

fugly16
Here is my 3080 FTW3 hybrid and Corsair 360mm AIO in a 5000D
 

Very nice!  That case is such a joy to work in. 
Girl-child's 5000D rig:

I have Thermaltake view 51 ARGB and it has loads of room and build options.
https://www.amazon.de/-/e...s=computers&sr=1-1

im using the hyte y60 case. i have the cpu 360 rad in the top and the 3080ti hybrid rad in the side, seems to work perfectly, everything is set for exhaust. in the basement of the case i have 2 140 fans blowing cool air into the chamber . if u havent seen this case yet, ck it out.