Hi!!!
Well, this weekend to finish the pc but thought amused me with some improvements.
First fabricate a cover for the motherboard to plug the rear connectors of the plate. First take measurements and draw in cardboard then cut it and present it on the plate.
Despues lo pase al aluminio, corte, lime y plegado...
After you pass the aluminum, cut, lime and folding ...
And present on the motherboard...
Then I play the relevant painting session, not take pictures sorry, but mounted on the board you will see in the following photos.
I made some changes in the RL, I returned to deposit Aquacomputer and I liked a lot more aesthetic that gave the set so manufactures aluminum support also remains hidden behind. You up out photos in the next update.
After this happens wiring that was not enough, place without plugging in to power but all ordenadito, as God intended. It could be improved as wired but is too big and is another world.
And finally the RGB LED strips lighting controlled by farbwerk and aquaero
And this is all that gave the weekend.
Next week I will have to make a small adjustment because me is impossible to fill the circuit, an air pocket is created and does not enter the liquid. Seran 10 minutes to make 2 holes.
Regards!!!