You haven't tried manually changing the memory frequency 4400?

I had to manually override my memory 

I'm not suggesting they don't try that, I'm just saying it's odd that the xmp profile didn't work right for the speed setting. Might be something the folks at EVGA would like to know.

Of course I can change that manually, but the board should read the XMP profile normally correct.
I will open a ticket...

Seems like a problem on EVGA side

As an update my Crucial 3600 Ballistix Ram seems to be functioning as memory correctly. However, the aRGB is a nightmare it seems, their crappy software is constantly freezing on the 32bit install, Can't run the 64bit because it says the Mobo isn't compatible. I might be on the hunt for some replacement memory with decent aRGB software. I never had issues in the past with my gskill. Should have went with one of their kits they tested on the z590 FTW

i really with EVGAs software would pick up the RGB on the ram.....  I refuse to install the gskill software so rainbow wave it is.  

I haven't used it but I hear OpenRGB is good. Might want to give it a try.

Udo_G
Of course I can change that manually, but the board should read the XMP profile normally correct.
I will open a ticket...

did EVGA get back to you about it? I didn't bother opening up a ticket and just did it myself. I'm sure an updated bios is in the works to have the memory to run on what it is intended to be with XMP 1 or 2

Nike_7688

Udo_G
Unfortunately my memory is not recognized correctly:
Memory = BLM2K16G44C19U4B
Specification = DDR4-4400, CL19-19-19-43
 
The mainboard only recognizes 4267 MHz instead of 4400 MHz (XMP 1):
 
In which way can I inform EVGA about this issue - via support ticket?

Yes, I think a support ticket would be the best way to go.

on the site it is listed at 43 but if you look on the memory stick it might say 46 on it. It’s very misleading