2021/03/12 20:07:33
kikkoman123
micfogas
How picky is this block with pad thickness/position? I mean obviously they have to line up, but anyone have an issue with the cold plate not making good enough contact with the die?



ive read some people in the past had some issues with 2080/1080 blocks. haven’t read anything on the 3080/90 block so far. it’s cnc machined if that matters. 
2021/04/12 09:08:36
critofur
Lord Winchester
The Build is done BTW [pic removed]



Very nice, but, one thing would drive me nuts: the angle of your GPU card - how come it's angled like that? 
2021/04/12 21:52:55
kikkoman123
critofur
Lord Winchester
The Build is done BTW [pic removed]



Very nice, but, one thing would drive me nuts: the angle of your GPU card - how come it's angled like that? 


its angled horizontal. do u see something else?
2021/04/15 22:09:00
Rustlinjimmies
So I ordered a byski block but found someone selling an ek block local never used so I said screw it but then I stuumbled on the thread of the ek blocks bricking the ftw3 cards so now im on the fence if I should just a avoid the ek block now. Any advice would be lovely thank you 
2021/04/16 07:50:04
phroze
kikkoman123
critofur
Lord Winchester
The Build is done BTW [pic removed]



Very nice, but, one thing would drive me nuts: the angle of your GPU card - how come it's angled like that? 


its angled horizontal. do u see something else?


I think he is talking about Lord Winchester's. Looks like it is running down hill. I used the EK bracket to avoid that issue.
2021/04/18 01:23:34
kikkoman123
Rustlinjimmies
So I ordered a byski block but found someone selling an ek block local never used so I said screw it but then I stuumbled on the thread of the ek blocks bricking the ftw3 cards so now im on the fence if I should just a avoid the ek block now. Any advice would be lovely thank you 


can u post a link to the thread about ek blocks bricking?
 
u cancel yer order for the bykski block?
 
side note: i changed my setup to bottom intake, side exhaust p/p rad and top exhaust rad, rear single intake.
 
 
2021/04/21 17:58:39
rrusek
Can you please PM me with guide/breakdown video of putting a Bykski water block on a 3080 FTW3 ULTRA.
 
I would PM you but am new to the forum so I do not have enough posts to be able to pm people.
 
Thanks,
RJR
2021/04/28 19:56:24
rrusek
Can anyone confirm that they have or have not used the supplied washer / spacers for the 3080?
 
I have been reading that they are only required for the 3090?
 
Thanks,
RJR
2021/04/28 19:59:55
rrusek
Also can the supplied thermal pads be used for the installation?  I have read that you need 1mm pads for the vram and 1.5 for everything else.
 
Thanks,
RJR
2021/04/28 20:02:01
rrusek
Can someone specify what temps you are getting for the memory under load?  I am getting 80c, is that normal?
 
Thanks,
RJR

Use My Existing Forum Account

Use My Social Media Account