Increasing voltage makes alot of heat, ofc my ambient is high right now 😆
Edit- I'm pushing about 590w average during port royal 😆

Did you get an updated Classified Tool that's newer than the one that most folks are using?  Or is it the same?  One I'm using is the 3.1.4.0 one.

http://www.3dmark.com/pr/1062755
holy hell this took a ton of voltage and power to get it to complete, had one run where i was holding 2.2ghz and averaging 680-690w of power draw(this success was a little less power but not a lot less, possible my psu ran out of steam and failed it) and got to the point where the chick just walked out of the ship then it crashed :(

Dabadger84
Did you get an updated Classified Tool that's newer than the one that most folks are using?  Or is it the same?  One I'm using is the 3.1.4.0 one.

new one -_-
3.1.7

Let's bump that voltage another notch 👌
Got to love that 160w idle 😆🤣

http://www.3dmark.com/pr/1062773
wooop
held 2.2 whole time, pulled average over 700w, and didnt crash
best part is I am #3 for 5800x and single 3090 now XD

Hey Dabadger, you should try this, it's fun :)

Old or not, I need to have that.
 

CptT95

Dabadger84
Did you get an updated Classified Tool that's newer than the one that most folks are using?  Or is it the same?  One I'm using is the 3.1.4.0 one.

new one -_-
3.1.7

1.3 on core? and you are running XOC? on Water?
 
What was your baseline for the LN2 bios that came with the card?
 
Just trying to figure did the XOC improve your score? same classified tool settings as previous bios you were using?
 
EDIT: Ah, forgot you are on the HC.

That’s too much NVVDD and score isn’t scaling correctly with the wattage its pulling. Try 1.25v NVVDD and tweak MSVVDD, 1.10v is too low. 1.25v NVVDD 1.15-1.175v MSVVDD should pull 620W and have better score. Nice memory OC