XrayMan
yodap
XrayMan
yodap
Woke up on the 2nd to a rig that could not reboot. (Page fault in a non paged area) or some such message. Should not have updated on it’s own but will try to figure out if this update may be responsible. Rig was crunching for the Formula Boinc race over night. When the race is over I’ll try again but booted in to Linux to finish the race and all is good with the hardware.
You reported problems last time too. Bad luck, or the rigs just can't handle the updates without a problem?
Generally my rigs update well, and I’m not entirely sure this issue was a result of an update. If it wasn’t I will post back and clarify it. Have to wait until Monday though.
Ok. Sounds good.
Everything looks good now, updated to KB4023057 successfully and have not done the optional KB5005101 yet. That should be the next patch Tuesday update.
I don't believe the update was the issue but might have contributed in combination with the crunching tasks that used a lot of memory per task. Was running 8/8 cores so lots of RAM being chewed up.