All good here after this round of updates.

 
Cumulative Update - September 1, 2021—KB5005101 (OS Builds 19041.1202, 19042.1202, and 19043.1202) Preview
 
 
 
September 1, 2021—KB5005101 (OS Builds 19041.1202, 19042.1202, and 19043.1202) Preview (microsoft.com)
 
 
 
KB4023057: Update for Windows 10 Update Service components
 
 
 
KB4023057: Update for Windows 10 Update Service components (microsoft.com)
 
 
 
 
 
No problems to report.

Updated with no issues to report...

Thank you, updated today, nothing amiss yet, so all is good.

Good to go here as well.

Woke up on the 2nd to a rig that could not reboot. (Page fault in a non paged area) or some such message. Should not have updated on it’s own but will try to figure out if this update may be responsible. Rig was crunching for the Formula Boinc race over night. When the race is over I’ll try again but booted in to Linux to finish the race and all is good with the hardware.

yodap
Woke up on the 2nd to a rig that could not reboot. (Page fault in a non paged area) or some such message. Should not have updated on it’s own but will try to figure out if this update may be responsible. Rig was crunching for the Formula Boinc race over night. When the race is over I’ll try again but booted in to Linux to finish the race and all is good with the hardware.

You reported problems last time too. Bad luck, or the rigs just can't handle the updates without a problem?

XrayMan

yodap
Woke up on the 2nd to a rig that could not reboot. (Page fault in a non paged area) or some such message. Should not have updated on it’s own but will try to figure out if this update may be responsible. Rig was crunching for the Formula Boinc race over night. When the race is over I’ll try again but booted in to Linux to finish the race and all is good with the hardware.

You reported problems last time too. Bad luck, or the rigs just can't handle the updates without a problem?

Generally my rigs update well, and I’m not entirely sure this issue was a result of an update. If it wasn’t I will post back and clarify it. Have to wait until Monday though.

yodap

XrayMan

yodap
Woke up on the 2nd to a rig that could not reboot. (Page fault in a non paged area) or some such message. Should not have updated on it’s own but will try to figure out if this update may be responsible. Rig was crunching for the Formula Boinc race over night. When the race is over I’ll try again but booted in to Linux to finish the race and all is good with the hardware.

You reported problems last time too. Bad luck, or the rigs just can't handle the updates without a problem?

Generally my rigs update well, and I’m not entirely sure this issue was a result of an update. If it wasn’t I will post back and clarify it. Have to wait until Monday though.

Ok. Sounds good.

I've been lucky so far that I haven't had any update issues lately. As soon as Windows 11 is available I will either update or make a fresh install.