I decided to change cases so I tore down my rig and rebuilt it in a Caselabs Mercury S5. All new piping but nothing else changed. So I put some water in it and went to check for leaks and it starts, the fans spool for a quick second and it shuts down. Checked my switch connections and they were good so I went and hit the cmos button. It did the same thing so I hit the mobo reset button and it runs a bit longer as long as I am holding it down. It ran perfectly when I tore it down so I am totally at a loss. Any help would be appreciated.

Note: this case does not have a reset so I just have it pinned to power and led.

Yeah, I broke down and called support. Didn't think about memory. It's all covered up in that area so putting the memory back in didn't even cross my mind.

sinned.
Yeah, I broke down and called support. Didn't think about memory. It's all covered up in that area so putting the memory back in didn't even cross my mind.

 
So their was No Memory Installed on the MB?

Jack
Yeah, it ran all night. I've been pretty lucky after all the liquid cooled builds I've done I've had 0 leaks. With the exception of the primochill res leaks but that was caught way before I was ready to run.