a213m
SSC Member
- Total Posts : 877
- Reward points : 0
- Joined: 2006/02/08 11:10:24
- Location: ๐จ๐ฆ
- Status: offline
- Ribbons : 20
Old build. This is a planned refresh since a long time ago. This isn't really an upgrade. The base hardware is still the same, I'm still running the same 7920X CPU, the motherboard is still X299 and the videocards are still the same, I haven't upgraded to RTX 2080 Ti's. I only replaced my Strix X299 board with Prime X299 Deluxe. Moved my 10G network card to the slot between the videocards. Loopwise I replaced all clear tubing with black one, added a drain valve and added a flow meter, then I removed it, thus it's not on the photos. The flow meter was barely registering any RPM signal, due to low pump speed, so I removed it. Next time I'll move to a new case, and will try a hardline tubing, because the amount of extenders, adapter, and fittings I used to keep straight runs is getting out of hands. The run between the back radiator and the top videocard uses 6 parts, and the run between the front radiator and the res uses 13 parts. What do you think?
post edited by a213m - 2019/07/02 18:12:22
My free and open source SDR-DDR5 SPD reader/writer with write protection capabilities New: 13900K, Z790 HERO, 2x32GB 6800C32, 4090, 2TB SN850, AX1600iOld: 10980XE, X299SE2, 8x8GB 4000C15, 4090, 2TB SN850, AX1600i
|
Cool GTX
EVGA Forum Moderator
- Total Posts : 30975
- Reward points : 0
- Joined: 2010/12/12 14:22:25
- Location: Folding for the Greater Good
- Status: offline
- Ribbons : 122
Re: Refreshed my PC
2019/05/18 18:16:57
(permalink)
Very Nice Rig  I see the EK blocks - Are the fittings also EK ? I've been very happy with my Alphacool radiators
|
a213m
SSC Member
- Total Posts : 877
- Reward points : 0
- Joined: 2006/02/08 11:10:24
- Location: ๐จ๐ฆ
- Status: offline
- Ribbons : 20
Re: Refreshed my PC
2019/05/18 18:20:28
(permalink)
No, I used a mixture of Bitspower, Barrow and other unknown brand fittings. The only EK parts are the waterblocks and the D5 dual bay res.
My free and open source SDR-DDR5 SPD reader/writer with write protection capabilities New: 13900K, Z790 HERO, 2x32GB 6800C32, 4090, 2TB SN850, AX1600iOld: 10980XE, X299SE2, 8x8GB 4000C15, 4090, 2TB SN850, AX1600i
|
RobertC
EVGA Alumni
- Total Posts : 24
- Reward points : 0
- Joined: 2019/01/15 16:35:12
- Status: offline
- Ribbons : 0
Re: Refreshed my PC
2019/05/18 19:21:35
(permalink)
Ek sure does make some fine water blocks 
|
notfordman
Omnipotent Enthusiast
- Total Posts : 10345
- Reward points : 0
- Joined: 2007/08/09 23:52:23
- Location: In a van, down by the
- Status: offline
- Ribbons : 28
Re: Refreshed my PC
2019/05/19 00:25:38
(permalink)
Love those thick rads! Are they 60mm thick?? I like the look of the fittings. Nicely done! +1 
|
Hoggle
EVGA Forum Moderator
- Total Posts : 10101
- Reward points : 0
- Joined: 2003/10/13 22:10:45
- Location: Eugene, OR
- Status: offline
- Ribbons : 4
Re: Refreshed my PC
2019/05/19 00:46:51
(permalink)
Looks nice and I liked you going over what you did in the change from your old build to the refresh.
|
rjohnson11
EVGA Forum Moderator
- Total Posts : 102253
- Reward points : 0
- Joined: 2004/10/05 12:44:35
- Location: Netherlands
- Status: offline
- Ribbons : 84
Re: Refreshed my PC
2019/05/19 01:00:31
(permalink)
|
a213m
SSC Member
- Total Posts : 877
- Reward points : 0
- Joined: 2006/02/08 11:10:24
- Location: ๐จ๐ฆ
- Status: offline
- Ribbons : 20
Re: Refreshed my PC
2019/05/19 02:44:15
(permalink)
notfordman
Love those thick rads! Are they 60mm thick??
The back one is 60mm (UT60 crossflow), the front one is 80mm (Monsta). Hoggle
Looks nice and I liked you going over what you did in the change from your old build to the refresh.
rjohnson11
Fantastic work.
Thank you.
My free and open source SDR-DDR5 SPD reader/writer with write protection capabilities New: 13900K, Z790 HERO, 2x32GB 6800C32, 4090, 2TB SN850, AX1600iOld: 10980XE, X299SE2, 8x8GB 4000C15, 4090, 2TB SN850, AX1600i
|
svaaaaaa
New Member
- Total Posts : 6
- Reward points : 0
- Joined: 2015/05/17 14:33:23
- Status: offline
- Ribbons : 0
Re: Refreshed my PC
2019/05/20 17:20:01
(permalink)
looks nice 
|
a213m
SSC Member
- Total Posts : 877
- Reward points : 0
- Joined: 2006/02/08 11:10:24
- Location: ๐จ๐ฆ
- Status: offline
- Ribbons : 20
Re: Refreshed my PC
2019/05/22 16:56:14
(permalink)
My free and open source SDR-DDR5 SPD reader/writer with write protection capabilities New: 13900K, Z790 HERO, 2x32GB 6800C32, 4090, 2TB SN850, AX1600iOld: 10980XE, X299SE2, 8x8GB 4000C15, 4090, 2TB SN850, AX1600i
|
RainStryke
The Advocate
- Total Posts : 15872
- Reward points : 0
- Joined: 2007/07/19 19:26:55
- Location: Kansas
- Status: offline
- Ribbons : 60
Re: Refreshed my PC
2019/05/22 17:05:05
(permalink)
Main PC | Secondary PC
Intel i9 10900K | Intel i7 9700KMSI MEG Z490 ACE | Gigabyte Aorus Z390 MasterASUS TUF RTX 3090 | NVIDIA RTX 2070 Super32GB G.Skill Trident Z Royal 4000MHz CL18 | 32GB G.Skill Trident Z RGB 4266MHz CL17SuperFlower Platinum SE 1200w | Seasonic X-1250Samsung EVO 970 1TB and Crucial P5 1TB | Intel 760p 1TB and Crucial MX100 512GBCougar Vortex CF-V12HPB x9 | Cougar Vortex CF-V12SPB-RGB x5 3DMark Results:Time Spy|Port Royal
|
Delirious
EVGA Forum Moderator
- Total Posts : 17474
- Reward points : 0
- Joined: 2007/11/15 13:34:04
- Location: at my computer
- Status: offline
- Ribbons : 61
Re: Refreshed my PC
2019/05/28 06:14:50
(permalink)
looks really clean. Love the colors.
"Be quick to listen, slow to speak and slow to anger" Affiliate Code XZUMV9TJW5 Associate Code: 7PM43CU71IB2IAP education may be expensive but wait until you get the bill for ignorance A wise man once said that we can't make anyone feel or do anything. We can throw things into the wind, but it's up to each person to decide how they want to react, where they want to stand when things fall.
|
Gold Leader
CLASSIFIED Member
- Total Posts : 3939
- Reward points : 0
- Joined: 2009/05/30 03:06:17
- Location: Dirksland, The Netherlands
- Status: offline
- Ribbons : 62
Re: Refreshed my PC
2019/05/28 08:07:20
(permalink)
Nice clean build yet it looks like the PCB's of your 1080 Ti's looks a it warped unless it's from the camera lens hmm. Love the Icy bluehue's too, great job for the rest If you want em to add your system to the EVGA MODS RIGS List, make a post in this thread: https://forums.evga.com/FindPost/1588237
post edited by Gold Leader - 2019/05/28 08:15:27
|
a213m
SSC Member
- Total Posts : 877
- Reward points : 0
- Joined: 2006/02/08 11:10:24
- Location: ๐จ๐ฆ
- Status: offline
- Ribbons : 20
Re: Refreshed my PC
2019/05/28 21:26:21
(permalink)
The PCBs are fine, the powerlinks are a bit angled.
My free and open source SDR-DDR5 SPD reader/writer with write protection capabilities New: 13900K, Z790 HERO, 2x32GB 6800C32, 4090, 2TB SN850, AX1600iOld: 10980XE, X299SE2, 8x8GB 4000C15, 4090, 2TB SN850, AX1600i
|