Good morning guys,
 
I have a question about my Ram and Mobo.
I have recognized yesterday, that my DDR4 Ram is not running on the highest Mhz as it normally should. 
I tried to activate the XMP setting with 3000 mhz but my couldnt reboot after saving the settings.
 
Does someone have any advice for me :/ ?
 
regards oliver

I do have an i5-8400, bios 1.09 should be the newest!

Hyper X Predator 3000Mhz 2x8GB
HX430C15PB3K2/16

Ok, 3000 or less?
And do I have to care about the latency?
As example 15/35/35/60 idk what it means, but do I have to take care off?

Thank you will try it later or tommorow, I will let you know if it worked!

Well... there many settings, like TCL, tRCD/tRP, tRas, tRRD _ S, tRRD_L, tRTP, tFAW,tCWL and tCMD

" />

We can see one.
If you have a thumb drive plugged in and hit F12 on the screen it will export a screen shot, they will be much clearer then a picture with your phone of the screen
 
You can only have 500kb worth of attachments per post so you might have to make a few posts but primarily the first / top half of the memory page. I was going to let Sajin look at your shots and make the recommendations as to your settings

OGCrescent
I tried already, but he did not recognize my USB.
Thats why I ve uploaded it this way, I thought the Resolution and the sharpness should be fine, but If you cant See it or have problems with it, I try it again.
Thank you for your help so far!

Was it plugged into a hub? If so try plugging it directly into the back

Oh yea.. my fault, I will do it later!

I tried, sadly no succes :(

00,4C,FF error code

Did you try to up your voltages? Wouldn't hurt to try 2933.

Hmm. Maybe the cpu needs a small oc to be applied before the ram can run at 3000 MHz.

Your cpu isn't overclockable.