Hello
 
I am going to install the Hydro Copper on a 2080ti Ultra and I have some small questions (the pictures are too small on the assembly instructions)

The bracket provided in the bundle must be what way ?
On one side of the bracket, there are small edges and a black outline, I have to put the washers on the pcb (and on the side of the die) and the edges of the side of pcb ?

I would like to use the backplate Ek Waterblock, for that I have to use the screws #9 M2x5mm (screws for card not EVGA) ?
 
Thanks for your help

Ok thanks for the bracket position
I did not understand for the "I did not remove my Back Plate and be carful  doing so, it is on Rock Hard"
Why is not it advisable to use the ekwb backplate ?
 
Thanks

Ok thanks, I will ask ekwb, but since the Hydro Copper can be used with a card other than EVGA, no problem normally
 
and for "I did not remove my Back Plate and be carful  doing so, it is on Rock Hard" ?
You did not remove your backplate (leave that of EVGA), is that it ?

OK, thanks
The backplate EKWB is compatible with the EVGA block (up without problems) and all back plates are equal, so no worries