EVGA

Flow Control not saving to firmware.

Author
Post
Essentials Only Full Version
Fpschmitz
New Member
  • Total Posts : 22
  • Reward points : 0
  • Joined: 2017/12/10 15:08:12
  • Status: offline
  • Ribbons : 0
2019/01/03 15:26:11 (permalink)
Hi guys, I have a EVGA CLC 280, and today i noticed that flow control is not saving fan curve for CPU temp to the firmware, it only saves the fan curve for coolant temp. Every time I close Flow control, it returns to the coolant temp curve. SO every I boot up my pc I have to open Flow control and keep it open(thats annoying, because even on SSD i takes, the program take a little long to open). Looked for a solution here but didn't find any, and yes, I click on "apply" when i change the fan curve.
#1

1 Reply Related Threads
    thedude4bies
    New Member
    • Total Posts : 15
    • Reward points : 0
    • Joined: 2018/05/14 17:42:23
    • Status: offline
    • Ribbons : 0
    Re: Flow Control not saving to firmware. 2019/01/23 09:25:47 (permalink)
    FWIW, I find the fans get a little too crazy ramping up and down quickly with CPU curve due to sudden spikes during heavy use.  So, for me, using the coolant temp which is much more stable is better as the fans don't repeatedly speed up/down so quick.  That said, these fans are stupid loud.  I could probably tolerate the cpu fan curve with better fans.  Either way, I'm looking into getting better fans because this thing is just waaaaaay louder than my air-cool setup was.
    #2
    Jump to:
  • Back to Mobile