I'm having problems with the Custom setting on my Z15 keyboard. I just purchased this keyboard and I can do all of the presets, and solid color, but as soon as I create a custom setup with a few solid colors in it, and apply it, it will cycle to rainbow and then to the custom setup when toggling between profiles. It's a 1-2 second flash of rainbow, and then it kicks in. Sometimes when switching to that profile it just goes straight to rainbow and stays there but never to the custom color setup. When exiting Unleashed RGB, the "Apply" won't stick and it goes back to the rainbow swirl. Plus, if the board was set on the custom profile when the computer starts up it will start in rainbow and stay until the Unleashed software loads in startup. Also, when it shuts down the same in reverse, program shuts down, rainbow, then computer shuts down. Is this normal? I've tried it on two computers, factory reset the board, and uninstalled reinstalled the software in varying orders (no LED Sync software) and nothing has worked. I'm on the latest software v.1.0.6 with firmware v.1.23. Also, a lot of general settings for profiles won't stick when "Applied" and saved.