EVGA

Helpful Reply1.17 flash bsod ?

Author
Post
Essentials Only Full Version
Wesley_Fraser
Superclocked Member
  • Total Posts : 126
  • Reward points : 0
  • Joined: 2008/04/26 15:40:19
  • Status: offline
  • Ribbons : 1
2019/05/11 14:51:53 (permalink)
I know this sounds weird but I recently flashed to 1.17 bios from 1.07 on bios 1 for my x299 dark. all seemed fine until I started getting BSOD WHAE_UNCORRECTABLE_ERROR between 2-45 mins after the computer is brought back from a BSOD. I haven't installed anything new post bios flash ( or anything in general for a couple weeks). I wouldn't think a bios flash would cause inconsistent bsod. I swapped over to bios 2 (v1.07) and after 4 hours of attempting to recreate the bsod to no success. However, I turned the computer off swapped back to bios 1 (v1.17) and 5 mins into just sitting at the desktop with nothing launched besides steam running in system tray boom bsod again with the same error. I have done everything listed under microsofts page for that bsod call out and doesn't seem to do anything. 
 
Has anyone else run into this before either with the 1.17 bios or any other bios in the past?

My question is do yall think it was just a bad flash and should attempt flashing that bios again on slot 1 to see if that clears things up or maybe its a bigger issue? 
 






#1
List Solutions Only

17 Replies Related Threads
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/11 14:57:05 (permalink) ☄ Helpfulby Wesley_Fraser 2019/05/11 18:45:20
    Did you set the Bios back to the Defaults BEFORE you updated to 1.17.
    If not then then enter back into the Bios and then Press the Small Red Button on the Motherboard.
    This well reset the Bios and force you back into the Bios.
    Then Re-Flash with Bios 1.17. I am not seeing Any Issues with this Bios.
    "WHAE_UNCORRECTABLE_ERROR" Overclock to high on CPU
    From Bios 1.07 to 1.17 is a VERY Large Jump and you will need to redo your Overclock Settings in the Bios.
    The Settings you used under Bios 1.07 most likely Not would under  1.17.
    You will also need to redo the Overclocking on your Graphics Card as well.
     
    Note: This Applies ONLY to EVGA Motherboards and No Other Brands of Motherboards.
    post edited by bcavnaugh - 2019/05/11 20:20:56

    Associate Code: 9E88QK5L7811G3H


     
    #2
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/11 15:00:51 (permalink)
    I did reset to default via bios and confirmed default on everything prior to the flash. I am just going to re-flash that bios again and see if anything changes. Just wondering if anyone has experienced this with bios flashing. If worst comes to worst ill just run on 1.07
     
    I will go ahead and do the cmos clear in the 1.17 Bios prior to re-flashing again just to be extra sure everything is cleared. 






    #3
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/11 15:03:15 (permalink)
    Keep us Posted...

    Associate Code: 9E88QK5L7811G3H


     
    #4
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/11 18:33:59 (permalink)
    Update after 3 hours of re-flashed 1.17:
     
    Ran aida 64 stability with cpu cpu cache memory and gpu selected for 2 hours. No bsod thus far. 99.99 % sure re-flashing fixed the issue. Will update if any further bsod happen. 

    Huge thanks to Bcavnaugh. 






    #5
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/11 18:37:29 (permalink)
    Wesley_Fraser
    Update after 3 hours of re-flashed 1.17:
     
    Ran aida 64 stability with cpu cpu cache memory and gpu selected for 2 hours. No bsod thus far. 99.99 % sure re-flashing fixed the issue. Will update if any further bsod happen. 

    Huge thanks to Bcavnaugh. 

      Game On
    You are very welcome.

    Associate Code: 9E88QK5L7811G3H


     
    #6
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/12 10:11:13 (permalink)
    Unfortunately the bsod came back late last night. Thought I might have figured out what was triggering it but cant seem to replicate it this morning to no success. This go around it happened while encoding on one of my 2080ti KPs. removed all nvidia drivers and did a fresh install of 430.64. I will update if it occurs again. Next step I am going to go with is reformatting and starting everything 100% fresh. 






    #7
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/12 10:48:18 (permalink)
    Wesley_Fraser
    Unfortunately the bsod came back late last night. Thought I might have figured out what was triggering it but cant seem to replicate it this morning to no success. This go around it happened while encoding on one of my 2080ti KPs. removed all nvidia drivers and did a fresh install of 430.64. I will update if it occurs again. Next step I am going to go with is reformatting and starting everything 100% fresh. 

    First I would go back to Driver 425.31
    "one of my 2080ti KPs" do you have Two Cards installed?
    Then Test with One Memory Stick to see if you have bad memory.

    Associate Code: 9E88QK5L7811G3H


     
    #8
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/12 10:50:48 (permalink)
    I kind of hope its a bad ram stick. Will give me an excuse to the lady for spending more money on the pc






    #9
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/12 11:01:49 (permalink)


    Associate Code: 9E88QK5L7811G3H


     
    #10
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/12 11:03:02 (permalink)
    Yes I do have Two 2080ti KPE running in SLI






    #11
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/12 11:08:15 (permalink)
    Wesley_Fraser
    Yes I do have Two 2080ti KPE running in SLI

    With an EVGA NVLink Bridge or one from EVGA?
     

    Associate Code: 9E88QK5L7811G3H


     
    #12
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/12 11:16:09 (permalink)
    I am using the nvlink from evga
    post edited by Wesley_Fraser - 2019/05/12 11:23:29

    Attached Image(s)







    #13
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/12 11:37:22 (permalink)
    I have that Case, where are your KP Radiators mounted?

    Associate Code: 9E88QK5L7811G3H


     
    #14
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/12 11:43:14 (permalink)
    under the scythe fans 






    #15
    bcavnaugh
    The Crunchinator
    • Total Posts : 38977
    • Reward points : 0
    • Joined: 2012/09/18 17:31:18
    • Location: USA Affiliate E5L3CTGE12 Associate 9E88QK5L7811G3H
    • Status: offline
    • Ribbons : 282
    Re: 1.17 flash bsod ? 2019/05/12 11:56:58 (permalink)
    Got it, you can only see one of each fans.

    Associate Code: 9E88QK5L7811G3H


     
    #16
    Wesley_Fraser
    Superclocked Member
    • Total Posts : 126
    • Reward points : 0
    • Joined: 2008/04/26 15:40:19
    • Status: offline
    • Ribbons : 1
    Re: 1.17 flash bsod ? 2019/05/12 11:58:29 (permalink)
    yeah bad photo skills are bad 






    #17
    XrayMan
    Insert Custom Title Here
    • Total Posts : 73000
    • Reward points : 0
    • Joined: 2006/12/14 22:10:06
    • Location: Santa Clarita, Ca.
    • Status: offline
    • Ribbons : 115
    Re: 1.17 flash bsod ? 2019/05/17 22:52:15 (permalink)
    Wesley_Fraser
    I kind of hope its a bad ram stick. Will give me an excuse to the lady for spending more money on the pc




    I can relate.      

                My Affiliate Code: 8WEQVXMCJL
     
            Associate Code: VHKH33QN4W77V6A
     
                 
     
     
                      
     
     
     
              
     
       
     
               
     
     
     
     
     
     
     
     
     
     
     
     
     
     
     



     
     
     
     
     
     &nbsp
    #18
    Jump to:
  • Back to Mobile