Re: X1 software help
2019/04/04 16:46:40
(permalink)
Just set the fans to where ya want them with px1. Then open up afterburner. Overclock with that.
I run both at the same time.. though I have the ftw3 water cooled so I dont have to worry about fan controls.
Anyways.. set the fans on px1, close it and it will stick.. run afterburner after for overclocks.
Px1 seemed to lock my voltage at 1.050v.
Intel i9 9900K @ 5.2Ghz Single HUGE Custom Water Loop.
Asus Z390 ROG Extreme XI MB
G.Skill Trident Z 32GB (4x8GB) 4266MHz DDR4
EVGA 2080ti K|NGP|N w/ Hydro Copper block.
34" Dell Alienware AW3418DW 1440 Ultra Wide GSync Monitor
Thermaltake Core P7 Modded w/ 2x EK Dual D5 pump top,2 x EK XE 480 2X 360 rads.1 Corsair 520 Rad.