Hey Y'all! Ready for thanksgiving? i am :-) Anyways on to my point. So i am building my new "puter" and i have the EVGA CLC280 In A push config. But being i had to install the rad in the front of the case i wanna do a push/pull setup. Now my ? since the 2 fans go to the pump wiring can i buy 2 of the EVGA fans that are on the rad and install them as pull and get a splitter and have all four running off the pump wiring, or will i have to use a spare Fan Header. My MOBO has a cpu fan/pump header, another Pump header which is where my pump wire is hooked to. i would like a push pull cuz i can run the fans at 40-50% and they should flow air as if it was 100%. Please let me know if i can or will i fry the wires/pump etc.