EVGA

DG-77 help

Author
SHIZZx1997
New Member
  • Total Posts : 1
  • Reward points : 0
  • Joined: 2019/02/11 00:04:00
  • Status: offline
  • Ribbons : 0
2019/02/11 00:05:15 (permalink)
looking at buying a dg-77 but i have an x299 dark for my build im building around that board will it even fit in the case?
#1

3 Replies Related Threads

    Cool GTX
    EVGA Forum Moderator
    • Total Posts : 16475
    • Reward points : 0
    • Joined: 2010/12/12 14:22:25
    • Location: Folding for the Greater Good
    • Status: offline
    • Ribbons : 112
    Re: DG-77 help 2019/02/19 11:47:39 (permalink)
    Welcome to the Forums

    Sorry for slow reply - I just found your post

    No it will not fit
     

    DG-77 only supports mITX , mATX & ATX sized MB
     
    DG-77 spec sheet
     
    X299 Dark is EATX sized MB
     
    In the Future just Call those helpful people in EVGA Customer Service with your purchase questions     https://www.evga.com/about/contactus/

    RTX Project EVGA X99 FTWK-5930K,EVGA2080Ti EVGA-1200P2  Nibbler EVGA X99 3-GPU Water Loop 1600P2  AIO Folding  1080Ti FTW3 Hybrid, 1200P

    Thank You for Your Support






    #2
    Hoggle
    EVGA Forum Moderator
    • Total Posts : 4732
    • Reward points : 0
    • Joined: 2003/10/13 22:10:45
    • Location: Eugene, OR
    • Status: offline
    • Ribbons : 3
    Re: DG-77 help 2019/02/19 12:20:00 (permalink)
    The DG-8 series should work for it or most full sized cases.

    Use an Associates Code & SAVE 5% - 10% on your purchase. Just click on the associates banner to save, or enter the associates code at checkout on your next purchase. If you choose to use my code I want to personally say "Thank You" for using it. 
     
     
    #3
    bill1024
    CLASSIFIED ULTRA Member
    • Total Posts : 7073
    • Reward points : 0
    • Joined: 2008/10/18 01:01:10
    • Status: online
    • Ribbons : 43
    Re: DG-77 help 2019/02/19 13:11:23 (permalink)
    I have the 76 and I am stuffing an EVGA x99 FTW or my x99 classified in there. They are EATX boards.
    But, I have a grinder with a cut off wheel and I had to use it!!! lol
    If EVGA would have the PSU and SATA connectors faced straight up and not off to the side it would of been a lot easier.
    Now I have to cram some radiators and a pump/res in there.  
    Good thing I own a drill, some bits and tin snips!!!

     Life is too short to carry a cheap pocket knife

     U25ITA93JV   
     
    #4
    Jump to:
  • Back to Mobile