Board won't POST after BIOS update

New Member
  • Total Posts : 1
  • Reward points : 0
  • Joined: 2018/12/04 05:27:09
  • Status: offline
  • Ribbons : 0
2018/12/04 05:36:35 (permalink)
I have a z270 Classified K motherboard and I did a BIOS update to 1.08 using the EVGA Windows installer.  According to the progress screen, the process completed properly, but when the system rebooted, it won't even POST.  Suggestions?

2 Replies Related Threads

    EVGA Forum Moderator
    • Total Posts : 36400
    • Reward points : 0
    • Joined: 2010/06/07 21:11:51
    • Location: Texas, USA.
    • Status: offline
    • Ribbons : 193
    Re: Board won't POST after BIOS update 2018/12/04 11:53:52 (permalink)
    Use the bios switch on the motherboard to load up off another bios.

    Want to save 5 to 10% on your next EVGA purchase? Just click on the associates banner to save, or enter the associates code at checkout on your next purchase. If you choose to use my code I want to personally say "Thank You" for using it.

    EVGA Tech Support
    • Total Posts : 817
    • Reward points : 0
    • Joined: 2016/05/13 10:03:33
    • Status: offline
    • Ribbons : 7
    Re: Board won't POST after BIOS update 2018/12/04 12:58:44 (permalink)
    After you have booted up on the second BIOS (as Sajin suggested), while running in Windows, move the switch back the original position. Then you can attempt to flash the original BIOS position a second time (from Windows). This process can be repeated, but it does not work after two attempts, there is likely some other issue and we would recommend reaching out to our support staff, 888-881-3842.

    ...an untrammeled flow of words in an open forum.
    - Adlai E. Stevenson
    Have a moment? Please rate our service 
    Jump to:
  • Back to Mobile