I've been around the block and back trying to figure out why my LEDs aren't lighting up on this hydro copper water block.
Using Precision X1 v1.0.2
Firmware: 49.F9.68
Firmware: 2B.F9.68
Nvidia driver up to date (V442.19)
Bios up to date (Asus z270e): v1302
I've connected the pin from the waterblock to the top of the card per instructions of the manual.
But having no luck getting the LEDs to work.
I tried updating the MCU (2080_FTW3_E198) but when i go to run it (as admin), i get a Check sum error 0x2F.
I'm out of ideas other than that it's a faulty Hydro Copper waterblock?
Any ideas?