I'm running into some kind of bug on the high clock speeds with LinX.  

"Shock-the-Monkey" and I have both noticed this...  there seems to be some sort of memory leak in all the later versions of LinX.   It takes way too long on the first pass (250 sec)with very low gflops (35)... and as you continue... longer for each pass with less  and less gflops as you continue until you get a pop up that message from windows wanting to shut down stuff to create more memory. 

I noticed AWallGuy seemed to run his ok at 4.7ghz... but Monkey and myself both have this problem.

Any ideas anyone???

maybe.... depends on what your settings are and the main factor of this whole ordeal....having a 759 board.lol

everyone with these boards seems to have high azz stable over clocks being pushed.

I'm working on a 760 right now... my 759 needs a new cpu socket. 

so far...i have seen quite a few of those boards out doing the 760/761...

but isn't STM Board a 760?

johnksss

so far...i have seen quite a few of those boards out doing the 760/761...

but isn't STM Board a 760?

Yep. Mines a 760. Seems everything I try with LinX gives me either a x50 error or x0a error. Real pain. Yet I can run Prime with no problem.

just looking for holes...guess we can count that one out...hummmm

Ahhh... that's better! 

4.75 ghz ht on!


 
 
I'm not sure why LinX would run slower with HT on???   1.5 hrs to run this!   I will have to check and see if I drop the cpu speed down if LinX runs faster... all  my other4.5 and 4.6 runs were around 1hr 5mins except that HT off run which was less than 1hr.
 
Going for 4.8 ghz now. 

40 gflops....

johnksss

40 gflops....

Ya... what's up with that... all I did was turn on HT... everything else was the same!

man, i have no clue. i want to run with the big dogs again...i may have to grab an extreme...