Ok I need some help. I raise my overclock to 4.8 Ghz and went all the way up to 1.65 vCore. It always Freezes a little over the start of CPU Test 1 of vantage. Any suggestions as I think I need to raise something other than vcore as I saw almost no difference when I raised it litle by little all the way to 1.65v
. My blood was pumping alot lol
here is the setting I used
Frequency Control CPU Clock Ratio ( 25x )
CPU Host Frequency (Mhz) (
193 )
MCH Strap ( Auto )
CPU Uncore Frequency (Mhz) ( Auto )
CPU Clock Skew ( 0 ps )
Spread Spectrum ( Disabled )
PCIE Frequency (Mhz) ( 105 )
Memory Feature Memory Speed ( Standard )
Memory Control Setting ( Enabled )
Memory Frequency ( 1066 / 2:8 )
Channel Interleave Setting ( 6 Way )
Rank Interleave Setting ( 4 Way )
Memory Low Gap ( Auto )
tCL Setting ( 7 )
tRCD Setting ( 7 )
tRP Setting ( 7 )
tRAS Setting ( 20 )
tRFC Setting ( Auto )
Command Rate ( 1T )
Voltage Control EVGA VDroop Control ( WITH VDroop )
CPU VCore (
1.65v )
CPU VTT Voltage (
+200mv )
CPU PLL VCore (
auto )
**IOH PLL VCore (
auto )
DIMM Voltage (
1.65 )
DIMM DQ Vref ( Auto) (+0mV)
QPI PLL VCore (
auto )
IOH VCore (
auto )
IOH/ICH I/O Voltage (
auto )
ICH VCore (
1.1)
**VTT PWM Frequency ( 250 KHZ )
**CPU PWM Frequency ( 800 KHZ )
**CPU Impedance ( Less )
**QPI Signal Compensation ( Less )
CPU Feature Intel SpeedStep ( Disabled )
Turbo Mode Function ( Enabled )
CxE Function ( Disabled )
Execute Disable Bit ( Disabled )
Virtualization Technology ( Disabled )
Intel HT Technology ( Enabled )
Active Processor Cores ( All )
QPI Control Settings ( Enabled )
QPI Link Fast Mode ( Enabled )
QPI Frequency Selection ( 4.800 GT/s )
OC Recovery ( Enabled )
PnP/PCI PCI Express Maximum Payload Size ( 128 )
Power Management Setup ACPI Suspend Type ( S3 )
HPET Support ( Enabled )
HPET Mode ( 64-bit )