looks like you plastic dipped parts of the front as well.

YES! Now BENCH!!

Man, this is getting ridiculous.
" target="_blank" rel="nofollow">http://img405.imageshack.us/img405/2508/img86241.jpg

My god... That's insane Q!

Q56_Monster

Man, this is getting ridiculous.
" target="_blank" rel="nofollow">[link=http://img405.imageshack.us/img405/2508/img86241.jpg]http://img405.imageshack...mg405/2508/img86241.jpg[/link]

really?
point me to the part that's getting ridiculous, because i dont see it?


but, i would try to peal off a corner to see how hard it will be to take off later though...

wow, 1/2" thick on the sides?  You might find it difficult getting card to stick in the slot with the excess of insulation.  I had to rig an alumn bracket to get it to brace it down.

Hmm I wonder how bad a DICE/LN2 pot is gonna be... You know what, I probably don't want to know.

Nate, it's the 3/8 EV foam on each side.  It's a little too thick, so I had to carve out a section so it would fit against the NB heatsink cooler.

@John, yea I know.  Now you...you're out of control my friend, LOL.  No, really, I wish I was doing what you are doing.  It shouldn't be too hard to get off, as there is a layer of eraser below the foam, and a number of coats of plasti-dip below that.  No sticky side of the foam is touching any raw component.

ok, almost there. time to test condensation one more time.  I was going to fire it up on the 780i board, but it won't fit at all, and I don't want to mod it for the 780i, since I'll never use it on that board anyway.  -23.4C now...almost time to turn the pump on.

just start benching already?!

I just want to make sure.  Tomorrow I get a new shipment of eraser to do the other card.  I might just put the HK 3 on for the weekend....alot of prep still to do.  Been working on this for 2 weeks I think.