Q56_Monster

Great job guys...you know, I never ran high or entry presets..

Awalleye...just out of curiosity, what make is the 5870.  I'm thinking of going with MSI or ASUS next time around.

XFX card.
  Where is x-cool jumper? Do not see it in the manual.

awalleyeguy

Q56_Monster

Great job guys...you know, I never ran high or entry presets..

Awalleye...just out of curiosity, what make is the 5870.  I'm thinking of going with MSI or ASUS next time around.

XFX card.
Where is x-cool jumper? Do not see it in the manual.

Bottom end off dimm slots

Just out of curiosity are any of you guys experiencing the turbo dropping out when hitting -45 and below
its driving me crazy its happening only on my 920 (both of them)(classy 760)

and i can't seem to find any thing about it else where!!!!

-45 huh....do any of us look like we are doing -anything right now??..ROTFLMAO! we are looking to you for that...lol

j/k

what do you mean dropping out exactly?
and what about running without turbo mode.

Ha ha John thanks
yeah it all boots fine i can boot in at -70 no probs but turbo is not on (even if its enabled in BIOS)
then if i run the system and warm it up to around -45 -35 turbo kicks in and away i go
but i need to keep it around -45 to use it, i then start the bench, drop the ice in cool it down and hopefully turbo stays engaged most cases it does but its a juggling act i can do with out.

you got me there sniper...never ran across that problem as of yet.....

            Thanks Sniper. Moving xcool jumper sets cpupll to 1.8 overrides my setting iohpll auto is still 1.8. CPU temp says -47 (its not) Going to see if does anything to run mem any faster  can run at 2300 or so already. And if I use eleete to change cpupll (bios does not change setting) system freezes.

and it removes the extreme cool settings in the bios

yeah Thanks John it could be something to do with speed step i might play around that cheers

yeah awalleye you can't trust the temps on the board....... u playing with dice?  i like your mem speed i'm jalousie

Bios, Eleet, Realtemp readings are all off after setting extreme cooling jumper. Bios sticks at -43 to -47. Eleet and Realtemp will show cores at -8 or there about. I found them to be around 20c or so off from Evap readings. If Evap on chiller read -30c CPU temp would be between -5 and -10c. This is around the temps of the cores would change from -8 and start moving up. I found it a little difficult to get a true temp reading with jumper set. Using bios settings and leaving jumper in default allowed a little better sense of what temps were. Mode 1 with Vapochill worked best. Mode 2 would work best with DICE and Mode 3 works best with LN2.