2010/01/31 18:39:52
johnksss
wrong os bra
2010/01/31 19:18:15
nateman_doo
Where is the "submit saved" section of 3d Mark 06?  I saved some results to the computer, but can't post the results
2010/01/31 20:16:02
reggiesanchez
I just found a huge hole in my gpu , no matter what I set the core clock to via perscion/nibitor/msiafterburner  I cant run anything between 810 and 837??????
2010/01/31 20:22:51
nateman_doo
reggiesanchez

I just found a huge hole in my gpu , no matter what I set the core clock to via perscion/nibitor/msiafterburner  I cant run anything between 810 and 837??????


Then set the core clock to 838... and get to work?? 
2010/01/31 20:40:02
reggiesanchez
Lol I am going to have to mod my block the vddc phase temps skyrocket if I set the voltage past 1.3 which it needs to be to run at 838 all the while the gpu is under 50 ill have to figure a way to make sure they make contact. Stuck at 11th for the single 280 vantage
2010/01/31 20:55:16
SniperOZ
Hay Nate open and right click on 3dmark 06 to get a drop down menu you should get a selection to submit saves

if you haven't already figured it out

Cheers
2010/01/31 21:09:10
johnksss
does he have to be registered?
2010/01/31 21:15:47
awalleyeguy
Nate push the cpu in older 3Dmark probably can run it higher than in vantage.
2010/01/31 22:02:16
ty_ger07
reggiesanchez

Lol I am going to have to mod my block the vddc phase temps skyrocket if I set the voltage past 1.3 which it needs to be to run at 838 all the while the gpu is under 50 ill have to figure a way to make sure they make contact. Stuck at 11th for the single 280 vantage


It it isn't too hard, due to block complexity, you can lapp the GPU portion of the block down a bit which will decrease the distance between the other portions of the board and the block and increase pressure on them.
2010/01/31 22:19:04
reggiesanchez
That sounds kina tough but ill try anything.

Use My Existing Forum Account

Use My Social Media Account