Second Fire Strike Bench at 1469MHz/2005MHz still at stock BIOS and Voltage.
 

Sweet.

how aggressive with water are you going to pump in there? 
 
Are you going to keep the cards above the dew point, or go full sub zero on them?  I would imagine you still need to disassemble the cards to waterproof them with some liquid rubber if nothing else.

nateman_doo
how aggressive with water are you going to pump in there? 
 
Are you going to keep the cards above the dew point, or go full sub zero on them?  I would imagine you still need to disassemble the cards to waterproof them with some liquid rubber if nothing else.

LOL, Yes Nate, I'm running as usual ATM Below the Dew Point for now.
 
Just for initial Testing, The Chiller Temps are set at +10C to see how the HC's operate at Stock Settings.

awalleyeguy
Sweet.

Thanks Man, We've only just begun.....

Third Fire Strike Test with the same previous Bench settings, Only THIS time changed Nvidia Drivers from 353.30 that was the Lowest I could use with my EVGA 980 Ti Classified (or Any Other 980 Ti series card I have tested), To an Older Driver 350.05 which made a BIG difference in Fire Strike Scores and allowing higher values on Precision X with K-Boost, Which was Just Like I knew they would!
 

Let me show you a Comparison of the SMALL differences in Fire Strike Scores I've seen so far between my Full-Blown GM200 EVGA Titan X Hydro Copper on +10C Chilled Water Cooling with the Stock BIOS running at 1495MHz/2005MHz and my Previous "Gimped" GM200 EVGA 980 Ti Classified's HIGHEST Score I could obtain using an XOC Modded BIOS on -17C Sub-Zero Phase Change Cooling running at 1590MHz/2000MHz.
 
As You can see, There is Only a 257 Point Difference, and I haven't even used a Modded Bios on the Titan X Hydro Copper or even pushed it hard Yet! LOL, LOL, LOL!
 
EVGA 980 Ti Classified:

 
 
EVGA Titan X Hydro Copper:

Outstanding!!!!
You definitely made the right move there bro. I was just yanking your chain on the KP's
I would go two way with those in a heart beat if I had the funds, hmmmm maybe I could start a fund me page!!! LOL 
I have always loved the look of the ek/evga blocks over any others, their just bad ...
will be looking for that thing back in the top ten,  five even...when you get that cpu slapped on their! nice work dude!!!

Pgcmoore
Outstanding!!!!
You definitely made the right move there bro. I was just yanking your chain on the KP's
I would go two way with those in a heart beat if I had the funds, hmmmm maybe I could start a fund me page!!! LOL 
I have always loved the look of the ek/evga blocks over any others, their just bad ...
will be looking for that thing back in the top ten,  five even...when you get that cpu slapped on their! nice work dude!!!

Thanks, I just KNEW from my previous tests with an Air Cooled Titan X that I needed that Unaltered GM200 Chip, Not even to mention the 12GB Memory. I don't even care that it's just a reference card PCB!
 
After I went over my testing/benching scores with numerous 980 Ti setups I tried, I was getting very disappointed with those results, So I decided to make a change......

how will you be linking the cooling on the sli, you gonna make your own from tubing? I saw a few swifteck connectors that may work well with them
 
http://www.swiftech.com/graphics.aspx