Teaprty
cpu loads around 61c @ 4.2ghz  running two dual 120 rads 8 fans push pull,the vregs never go above 60 and idle at 40c. im not sure where to read the NB temp from as i dont see it in eleet unless thats what system is and thats @ 31c right now. As far as the tridents go im running them @ 2000mhz 7-9-7-24 1T

Those temps are sweet, thanks for posting. Maybe I will stick with my 758 after all. I don't know if Eleet shows NB temp.. Everest does, or else in the BIOS screens.

Are the rads are in series (one rad flows directly into the next rad), and what is the sequence? (ie: are both immediately after the pump or what?).. I've seen another dual rad setup where they had one rad before the reservoir, then the pump, then another rad, then into the cpu block etc. Thanks again.

Also wonder if it's worth running a Y-splitter from the rad with one line to the CPU and the other to the VReg/NB heatsinks, and then a reverse Y back to the reservoir. Thoughts?

..maybe I should be asking this part on the o/c cooling & benching forum.

Problem with that is the lessor restrictive route will over power the more restricted route and cause higher temps on the more restrictive parts.

Nereus

Teaprty
cpu loads around 61c @ 4.2ghz  running two dual 120 rads 8 fans push pull,the vregs never go above 60 and idle at 40c. im not sure where to read the NB temp from as i dont see it in eleet unless thats what system is and thats @ 31c right now. As far as the tridents go im running them @ 2000mhz 7-9-7-24 1T

Those temps are sweet, thanks for posting. Maybe I will stick with my 758 after all. I don't know if Eleet shows NB temp.. Everest does, or else in the BIOS screens.

Are the rads are in series (one rad flows directly into the next rad), and what is the sequence? (ie: are both immediately after the pump or what?).. I've seen another dual rad setup where they had one rad before the reservoir, then the pump, then another rad, then into the cpu block etc. Thanks again.

my setup goes   Res>Pump>Rad>Rad>Vreg>NB/SB>CPU>Res
 
heres an everest shot everything idle

Is this the same water block for the X58  FTW3 768????
if no t could you guys recommend me one...
ps.   im just starting to use water cooling.. any advise would be highly aprecciated

Help to find drawings or where you can buy this waterblock for the chipset!