Does EVGA provide replacement modular cables for the Supernova NEX750B?  Just stock cables, not individually sleeved or anything fancy.  In fact, I only need one, for sata power.
 
Secondary question:  does anyone know the pinouts for the sata cable for this psu?  I have a few modular cables from other PSUs but I think they're wired differently.
 
Thanks!

Welcome to the forums.
 
1. Not that I know of..Using something like a widely available SATA Power Y-Splitter that makes two SATA power connectors from one won't work for you?
 
2. Yes, they may be (and often are) proprietary/wired differently at the PSU end..SATA power pinout on the component end can be found here..Pinout at the PSU end would need to come from EVGA..You can measure the voltage and remove the terminals and switch them around to the proper locations if necessary..Component end pinout is industry standard..There is no industry standard PSU end pinout, they can be different.

> SATA Power Y-Splitter …won't work for you?
 
Sorry, I was unclear. I don't have any of the modular cables for this PSU in the first place.  The only modular cables I have are from other (brands of) PSU's.
 
> Pinout at the PSU end would need to come from EVGA
 
This is what I suspected.
 
> You can measure the voltage and remove the terminals and switch them around to the proper locations if necessary
 
Well, could if I had a multimeter.  : )  
But yes, switching around the terminals is why I was looking for the pinout arrangement.
 
Thanks very much!

Well, I guess if all else fails and your other cables fit into the 750B you can hotwire the 750B and check the pinout voltages and rearrange the terminals if neccessary kinda like I said in post #2 here and make your own pinout diagram for the 750B..Some multimeters are dirt cheap..You can find practically all component end pinouts here..That's about all I can tell you..Good luck.