So, just to be clear, if you run the card with the 'issues' in the primary slot by itself (and no second card installed at all), you still see this?

Its normal, since frequency is tied to voltage what it means you need to your voltage, try setting voltage 100%. if still showing 1, increase frequency offset to force a higher voltage stepping.

EVGA_JacobF
Its normal, since frequency is tied to voltage what it means you need to your voltage, try setting voltage 100%. if still showing 1, increase frequency offset to force a higher voltage stepping.

Ok so if it's saying voltage limit 1 while runing the cards defaults "stock" and it's runing ingredients 1975mhz at 1.065v and that's not enough then I guess it's prob a bad card if it needs that much voltage.

And I can't wait to get home to test it with max voltage at that 1975.. cause if it don't go away wow.

I also believe I was able to lower the voltage at a certain mhz to get it voltage limit to 0.

Just tried it all stock in px oc with max voltage of 1.094v.

Starts out at 2000mhz at 2.94v and voltage limit "1" is on the whole time now for about 10 mins. After 3-4 mins I see that it dropped to 1987mhz and still 1.094v and voltage limit 1. Temps are at 52-54c fan speed 89% on my curve. Power 80-90%.

Ok just entered debug mode in NV control.

Ran defaults with firestrike graphic test 2 loop.

Right away it's at 1873mhz at 1.063v with you guessed it.. voltage limit 1!

Drops down to 1860 after a min and still 1.063v. Still voltage limit 1.

Temps at 50c fan at 89% after 5 mins or so.

What's this card rated speed? 1860.

How many times are you going to make a thread about this? 
 
http://forums.evga.com/He...-it-mean-m2549888.aspx
 
http://forums.evga.com/St...assified-m2549362.aspx

Hit it again this time with max voltage and it runs at 1886mhz in debug mode with 1.094v and yes.. voltage limit 1.

Edit.. after 10 mins or so has dropped to 1873mhz.. most likely going to drop to 1860mhz shortly. Will let it run to see if it drops below that.

Unsure what the rated specs are for the card at 1860mhz but is it at 1.65-1.1v cause I can't select a higher voltage and wondering why this chip passed the mark to be installed in a classified card.

Sounds like I gota embarrass myself again and go in there and tell them that I got 2 lemons in a row and need another.. ? Really? Only 1 out of 3 is good?

Sajin
How many times are you going to make a thread about this? 
 
http://forums.evga.com/He...-it-mean-m2549888.aspx
 
http://forums.evga.com/St...assified-m2549362.aspx

No one seen it in the other one.. and this is also a whole different card.. card 3.

Should I just keep one of the 2 ftw hybrid cards and use it in the 2nd slot??? Have 2 different cards just to have sli?

1 of the 2 hybrids has the black screen issue for sure and can't trust the other but god..