I purchased two EVGA SSC GTX 970s and am using an Asus X99 Deluxe mother board. Cards are in slot 1 and slot 4. Would the long bridge work for this? This is what I have now.
 
 
 
 

shadesdragon
 
I purchased two EVGA SSC GTX 970s and am using an Asus X99 Deluxe mother board. Cards are in slot 1 and slot 4. Would the long bridge work for this? This is what I have now.
 
 
 
 

I don't see the lengths shown on the website so my suggestion is that you contact EVGA tech support

atoff

Scarlet-Tech
Good luck :-D  Lots of people grabbing them immediately lol.

Are they only being produced for a limited time or something?  I see a couple of crazy people trying to sell them for $200/piece on Ebay.

People on eBay are fairly ignorant and abusive with their attempts to catch people off guard. It isn't a limited quantity things, it is more of a high demand for something new. I think I am going to grab one of these and one of the ROG bridges.

shadesdragon
 
I purchased two EVGA SSC GTX 970s and am using an Asus X99 Deluxe mother board. Cards are in slot 1 and slot 4. Would the long bridge work for this? This is what I have now.
 
 
 
 

Slot 1 and 4 would be 80mm apart. That would be the 3way bridge. In your picture, that looks like slot 1 and 2, which is the two way short at 40mm. Would the second set of fingers actually attach to the bottom card instead of folding the bridge, or not quite?
Could you post a clearer picture please?

shadesdragon
 
I purchased two EVGA SSC GTX 970s and am using an Asus X99 Deluxe mother board. Cards are in slot 1 and slot 4. Would the long bridge work for this? This is what I have now.
 
 
 
 

 
Based on your picture it looks like you can use the 2-way SLI (Long) connector. Single space in between dual slot cards.

Only wish that they had RGB capability.   I just stepped up to 3 way, so my old 2 way bridge is obsolete.    Both new and old styles look really good, but the white light clashes with my system.  

Might have to go with the ROG version just to get a red LED.   Other than that, well done. 

Dukman
Only wish that they had RGB capability.   I just stepped up to 3 way, so my old 2 way bridge is obsolete.    Both new and old styles look really good, but the white light clashes with my system.  

Might have to go with the ROG version just to get a red LED.   Other than that, well done. 

There is only two screws holding the shroud on. Simply remove it, and put a red light filter (local photo shop) over the back of the lettering. Done, 10 seconds is all it will take.

Can I use that one for a 3 Way SLI in that set up ?

shadesdragon
 
I purchased two EVGA SSC GTX 970s and am using an Asus X99 Deluxe mother board. Cards are in slot 1 and slot 4. Would the long bridge work for this? This is what I have now.
 
 
 
 

I have the same motherboard. 2-way long bridge (60mm) will work. Refer to post 152 on this thread.

sector-z


Can I use that one for a 3 Way SLI in that set up ?

No, it is wired differently.

When will the 4-way be out?  Is it possible to pre-order them?  It would look so much better than the one I have now.
 
4x EVGA GTX980's on water.