Erica647
That looks so good... wish I was comfortable building my own water-cooling setup.

Trust me when i say, there is no better place to start then this forum.  There are people here that can coach you through anything from changing a tire, reloading your own bullets, reprogramming the matrix, or building a watercooling system. 
 
Oh yea, and welcome to the forums!  If your interested in one of these, let me know.

Looking good nateman.

nateman_doo

Erica647
That looks so good... wish I was comfortable building my own water-cooling setup.

Trust me when i say, there is no better place to start then this forum.  There are people here that can coach you through anything from changing a tire, reloading your own bullets, reprogramming the matrix, or building a watercooling system. 
 
Oh yea, and welcome to the forums!  If your interested in one of these, let me know.

I need to reprogram the matrix... Maybe I should start a new thread for this. ;-D

Chipset block test fit:
 

 

Looking good, like the lady in the red dress

Looking good, it looks better then the stock non water cooling block no giant red E. 

Nate, I must ask about the heat pipe that runs from the chipset to the VRM. Does it make contact under the chipset side, or have any reason for the two to be connected? I was just curious what it looked like underneath the heat sinks.

can you help me reload my.... bfg50 lol

My board!!!

Kbeaumont5 i can help you load .50

Scarlet-Tech
Nate, I must ask about the heat pipe that runs from the chipset to the VRM. Does it make contact under the chipset side, or have any reason for the two to be connected? I was just curious what it looked like underneath the heat sinks.

Id have to dig them out.  
 
I hope to be cutting some delrin by the end of today.