cual lleva p sli ?? puente 
 

whitie63
Ok got mine to light up with my 760's 

 

Well good man you how did you manage it?

PointMan3763
sweet thanks will just ordered it should be here by Monday. also if I get another bridge to cover the other side will that mess up the cards having two sli bridges? I know its just for looks is what im going for...=]

you can use two bridges side by side but I thought the 2/3 way would work on your board though covering the four fingers. 

Dave Ord

whitie63
Ok got mine to light up with my 760's 

 

Well good man you how did you manage it?

 
 
LOL with a little modding if you look real close now there is a sleeved wire  coming out of it that i hooked up to a small strip led like this one with sticky on the back 
 

just grabbed a molex connector ran some sleeved wire to it and  Vooooila and it is something I can remove with out damage to the bridge  
 

Dave Ord

PointMan3763
sweet thanks will just ordered it should be here by Monday. also if I get another bridge to cover the other side will that mess up the cards having two sli bridges? I know its just for looks is what im going for...=]

you can use two bridges side by side but I thought the 2/3 way would work on your board though covering the four fingers. 

The only reason why I think the 2/3-way SLI bridge may not properly fit the Sabertooth Z87 is because if you refer to the first page, the 3-Way SLI bridge can accommodate 2-Way with DUAL slot spacing where the SLI fingers are 80 mm apart.  Like I mentioned above, the spacing between the SLI fingers on the Sabertooth Z87 is about 65 mm apart, which isn't too far off from 60 mm (the distance between SLI fingers with the 2-way SLI bridge).  80 mm is much longer than 60 or 65 mm, which is why I don't think the 2/3-way bridge will fit.  Of course, I could be wrong unless someone is willing to try it out and confirm it as I do like the wider 3-way SLI bridge and still hoping EVGA comes out with a double wide 2-way bridge lol. 

whitie63

Dave Ord

whitie63
Ok got mine to light up with my 760's 

 

Well good man you how did you manage it?

 
 
LOL with a little modding if you look real close now there is a sleeved wire  coming out of it that i hooked up to a small strip led like this one with sticky on the back 
 

just grabbed a molex connector ran some sleeved wire to it and  Vooooila and it is something I can remove with out damage to the bridge  
 

Where there's a will, there's a way. Congrats on your modding It looks great m8
There was a mention in an earlier post on doing it that way for cards that do not have the circuitry in their cards.
And you have proved it works well done 

I didn't see this thread before I posted in Modsrigs. Just a thought for those that don't own the 700 series: Link

raw2dogmeat
I didn't see this thread before I posted in Modsrigs. Just a thought for those that don't own the 700 series: Link

Well done raw2dogmeat I am sure it was your post I read

Have a GIGABYTE GA-G1.Sniper M5 LGA 1150 Intel Z87 SATA 6Gb/s uATX Intel Motherboard and the EVGA 02G-P4-3765-KR GeForce GTX 760 2GB 256-bit GDDR5 PCI Express 3.0 in 2 way sli can i get the EVGA Pro SLI Bridge (3-Way/2-Way) for up grades later on?
 
thank you