Forgive the noobness in me.....So no SLI bridge will work with my board?
 

PointMan3763
Forgive the noobness in me.....So no SLI bridge will work with my board?
 

The board will come with a SLI bridge that will fit. I was just referring to the EVGA Pro Sli bridges not being able fit that board. 

Got it. Iam using the bridge that came with the board now just wanted to bling it out abit. Cant seem to find anything else on a nice looking bridge to enhance the look of my rig.
 

Does not work with   EVGA 04G-P4-3768-KR GeForce GTX 760 FTW And yes I do have the right driver installed 

PointMan3763
Dave do you know the spacing setup on a sabertooth z87 SLI bridge? If its one space or two? Want to order the bridge now and need to be sure. Thanks =]

Your board has a two slot spacing so a 2way/3way could fit and I say could.
Firstly measure from the fingers on 1st card to the fingers on your 2nd card it should 80 cm
Make sure your system is powered off first, unless your using a plastic ruler.

whitie63
Does not work with   EVGA 04G-P4-3768-KR GeForce GTX 760 FTW And yes I do have the right driver installed 

It's nothing to do with  drivers.
The cards your using do not support the circuitry. It Only works on Titan, 780, and select 770's
There is no mention of the  760s
Read it here http://www.evga.com/articles/00766/ at the bottom of the page.

Thank you so much Sniper for the PM, you made my day!!!!! =] Just ordered the SLI bridge and the backplates for the 780's.
Thanks again!!!
And Thank you Dave for the input on the bridge =]

@ PointMan3763
 
FYI, I have the Sabertooth Z87 and the 2-way Pro SLI bridge, it WILL fit.  It has a single-slot spacing; spacing between the SLI fingers is approximately 65 mm, but it will fit appropriately without having to force anything into place.  I can't say the same thing for the 2/3-way Pro SLI bridge, but the 2-way will most definitely.  Hope this helps!

Ok got mine to light up with my 760's 

 

sweet thanks will just ordered it should be here by Monday. also if I get another bridge to cover the other side will that mess up the cards having two sli bridges? I know its just for looks is what im going for...=]