I received my EVBOT today and I am not finding where on the GTX 680 Classified Video to plug in the cable. Did I waste my hard earned money on the EVBOT? All 3 of my GTX 680 Classified Cards are new.
Thanks for any help,
Bill
I can connect it to my x79 FTW with no problems. Even updated the Firmware.

bcavnaugh...I am not finding where on the GTX 680 Classified Video to plug in the cable.

Newer 680 Classified videocards do NOT have the EVBot connector due to nVidia restrictions: at first they had it, then nVidia released a statement restricting some things and ordering EVGA not to include the connector anymore.
 
Anyway, you can buy the connectors (eBay) and solder them in its place, it works just as great as if it came already installed by EVGA. I have a 4-WAY SLI setup, and in one of the cards I had to go that way, buy the connector and solder it because I bougth that fourth card after nVidia's restriction date  =)

bcavnaughI received my EVBOT today and I am not finding where on the GTX 680 Classified Video to plug in the cable.

Check these links:
 
http://forums.evga.com/tm.aspx?m=1755509
 
http://kingpincooling.com/forum/showpost.php?p=23414&postcount=3
 

Then I hope that when the x79 Dark comes out I will get $50.00 off the price. (EVGA_JacobF) I hope that someone at EVGA reads this and updates the page below and REMOVE
Supported EVGA Products:

EVGA GTX 680 Classified  http://www.evga.com/articles/00521/
I would push this issue with EVGA_JacobF but I would rather him push out the x79 Dark and maybe some EVGA WaterBlocks 690 and 680 Classified that is.
Bill

Can i also flash with 780 classi?

That is very nice. 

 
 
Also regarding the EVbot, if I alter the voltages on my cards, is the change permanent or do I loose the over-clock once the machine is powered off.
 
Hopefully I am posting in the right place and someone will be able to assist.
 
 
EDITED: You would need to post in the WTB section for that, which you also need 50 posts to do, and auth from Evga. The WTB portion of this post has been edited out / deleted.

When will there be a firmware update for the EVBOT to support the 980 classified?

hello jpmboy :>

uh oh - flashed the new p56 firmware to my evbot for the 980Ti Kingpin.  Screen is showing the correct version but I get the "Failed" message if I try to adjust voltages.  what's up?