Merry Christmas everyone last night I left my computer on running Prime95 Blend test with these settings 

Mother Board ( EVGA X58 Classified E-760 )                                                         
Bios ( S61J )                                                                                                       
CPU ( 960 DO) 
CPU Cooler ( Prolimatech Mega Shadow )  
Memory ( Corsair Dominator GT 1600 7 7 7 20 )  
PSU ( Thermaltake 1000w)  
GPU ( EVGA GTX 295 Co-op )  
Drivers ( 195.81 )                                                                                                    
Operating System ( Windows 7  x64 Ultimate )  

Frequency Control  
CPU Clock Ratio ( 24x )                                                                                        
CPU Host Frequency (Mhz) ( 169 )                                                                        
MCH Strap ( Auto )  
CPU Uncore Frequency (Mhz) ( Auto )                                                  
CPU Clock Skew ( 0 ps )  
Spread Spectrum ( Disabled )  
PCIE Frequency (Mhz) ( 101 ) 

Memory Feature          
Memory Speed ( Standard )  
Memory Control Setting ( Enabled )  
Memory Frequency ( 1067 / 2:8 )                                                                  
Channel Interleave Setting ( 6 Way )  
Rank Interleave Setting ( 4 Way )  
Memory Low Gap ( Auto )  
tCL Setting ( 6 )  
tRCD Setting ( 6 )  
tRP Setting ( 6 )  
tRAS Setting ( 18 )  
tRFC Setting ( Auto )  
Command Rate ( 1T )  
Voltage Control  
EVGA VDroop Control ( With VDroop )  
CPU VCore ( 1.41875v )                                                                                                  
CPU VTT Voltage ( +100mv )  
CPU PLL VCore ( 1.500v )  
**IOH PLL VCore ( 1.500v )   
DIMM Voltage ( 1.73 )  
DIMM DQ Vref ( Auto) (+0mV)  
QPI PLL VCore ( 1.3 )  
IOH VCore ( 1.175 )  
IOH/ICH I/O Voltage ( 1.525 )  
**VTT PWM Frequency ( 370 KHZ )  
**CPU PWM Frequency ( 940 KHZ )  
**CPU Impedance ( Less )  
**QPI Signal Compensation ( Less )  
CPU Feature  
Intel SpeedStep ( Disabled )  
Turbo Mode Function ( Enabled )  
CxE Function ( Disabled )  
Execute Disable Bit ( Enabled )  
Virtualization Technology ( Disabled )  
Intel HT Technology ( Enabled )  
Active Processor Cores ( All )  
QPI Control Settings ( Enabled )  
QPI Link Fast Mode ( Enabled )  
QPI Frequency Selection ( 4.800 GT/s )  
OC Recovery ( Enabled )  

PnP/PCI     PCI Express  
Maximum Payload Size ( 4096  )  
   
Power Management Setup  
ACPI Suspend Type ( S3 )     
HPET Support ( Enabled )       
HPET Mode ( 64-bit )   



today when I woke up after 10 hours and 33 mins I got an error on core 4 it was doing the FTT 896k my question is that a cpu error or a memory error what would I need to change ? also is running prime95 for 10 hour and 33 mins enough time to call it quits and say its stable or keep testing it till I reach the 12 hour mark?                                                        

yea I call it quits for the time being unless I see a BSOD I will stay with these settings I am at right now I have spent the last week just overclocking my new rig now its time to finally enjoy it thanks all your help everyone